[U-Boot] [PATCH 3/4] net: rtl8169: Add support for RTL8168d/8111d

[Thierry Reding]

This chip is compatible with the existing driver, except that it uses
BAR2 instead of BAR1 for the I/O memory region. Using this patch I can
use the PCIe ethernet interface on the CompuLab Trimslice to boot from
the network.

Signed-off-by: Thierry Reding <treding at nvidia.com>
---
 drivers/net/rtl8169.c | 18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)

diff --git a/drivers/net/rtl8169.c b/drivers/net/rtl8169.c
index c61e015..c217e6f 100644
--- a/drivers/net/rtl8169.c
+++ b/drivers/net/rtl8169.c
@@ -246,6 +246,7 @@ static struct {
 	{"RTL-8169sc/8110sc",	0x18, 0xff7e1880,},
 	{"RTL-8168b/8111sb",	0x30, 0xff7e1880,},
 	{"RTL-8168b/8111sb",	0x38, 0xff7e1880,},
+	{"RTL-8168d/8111d",	0x28, 0xff7e1880,},
 	{"RTL-8101e",		0x34, 0xff7e1880,},
 	{"RTL-8100e",		0x32, 0xff7e1880,},
 };
@@ -314,6 +315,7 @@ static const unsigned int rtl8169_rx_config =
 
 static struct pci_device_id supported[] = {
 	{PCI_VENDOR_ID_REALTEK, 0x8167},
+	{PCI_VENDOR_ID_REALTEK, 0x8168},
 	{PCI_VENDOR_ID_REALTEK, 0x8169},
 	{}
 };
@@ -914,11 +916,25 @@ int rtl8169_initialize(bd_t *bis)
 	int idx=0;
 
 	while(1){
+		unsigned int region;
+		u16 device;
+
 		/* Find RTL8169 */
 		if ((devno = pci_find_devices(supported, idx++)) < 0)
 			break;
 
-		pci_read_config_dword(devno, PCI_BASE_ADDRESS_1, &iobase);
+		pci_read_config_word(devno, PCI_DEVICE_ID, &device);
+		switch (device) {
+		case 0x8168:
+			region = 2;
+			break;
+
+		default:
+			region = 1;
+			break;
+		}
+
+		pci_read_config_dword(devno, PCI_BASE_ADDRESS_0 + (region * 4), &iobase);
 		iobase &= ~0xf;
 
 		debug ("rtl8169: REALTEK RTL8169 @0x%x\n", iobase);
-- 
1.8.4