[U-Boot] [PATCH v2 2/2] mx6sabresd: Reset counter to prevent error message

[Stefano Babic]

On 11/09/2013 23:14, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
> 
> If a HDMI cable is not connected, the following message is seen on boot:
> 
> CPU:   Freescale i.MX6Q rev1.1 at 792 MHz                                       
> Reset cause: POR                                                                
> Board: MX6-SabreSD                                                              
> DRAM:  1 GiB                                                                    
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1, FSL_SDHC: 2                                    
> No panel detected: default to HDMI                                              
> unsupported panel HDMI 
> 
> Reset the 'i' variable to fix the 'unsupported panel' message.
> 
> This follows the same idea of commit 47ac53d7ae (imx: nitrogen6x/mx6qsabrelite: 
> Fix bug in board_video_skip).
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---


Applied to u-boot-imx, thanks!

Best regards,
Stefano Babic



-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================