[U-Boot] [PATCH V4 01/17] usb: gadget: mv_udc: don't check CONFIG_USB_MAX_CONTROLLER_COUNT

[Troy Kisky]

On 9/22/2013 5:05 PM, Marek Vasut wrote:
> Dear Troy Kisky,
>
>> On 9/20/2013 3:45 AM, Marek Vasut wrote:
>>> Dear Troy Kisky,
>>>
>>>> i.mx6 has 1 otg controller, and 3 host ports. So,
>>>> CONFIG_USB_MAX_CONTROLLER_COUNT can be greater than 1
>>>> even though only 1 device mode controller is supported.
>>>>
>>>> Signed-off-by: Troy Kisky <troy.kisky at boundarydevices.com>
>>> The problem is, will the 3 additional ports still work? I suspect they
>>> will, but then if you run 'usb reset', the gadget port will also be
>>> switched back into USB Host function, no
>>>
>>> Best regards,
>>> Marek Vasut
>> The next patch checks the OTG id before switching to host mode. If it is
>> grounded, then it enters
>> host mode, otherwise it doesn't.  But, running 'usb reset' on a
>> netconsole may kill your connection.
> It won't if you properly ignore rhis one controller depending on the OTG pin
> then, no ?
>
I can return an error code from ehci_hcd_init, so that ehci_reset will 
not be called. But then
usb_lowlevel_init will also return an error, which is good for the call 
from usb_init, but bad
for the call in usb_gadget_register_driver.

Perhaps I should return a 1, instead of 0, when the otg_id pin is high? 
And check for < 0
before aborting from usb_gadget_register_driver ?

Thanks
Troy