[U-Boot] [PATCH] i2c:zynq: I2C multi-bus support on Zynq

[Michael Burr]

Oh, OK. I see what you mean. I'm still very new to this process,
so it takes some practice to "learn the customs". Thanks for
clarifying.

So, in future I will keep those explanations below the "---" line.

Michael Burr  //  Software Engineer II

Logic PD
T // 612.436.7273
NOTICE: Important disclaimers and limitations apply to this email.
Please see this web page for our disclaimers and limitations:
http://logicpd.com/email-disclaimer/


-----Original Message-----
From: Michal Simek [mailto:monstr at monstr.eu] 
Sent: Tuesday, September 24, 2013 10:19 AM
To: Michael Burr
Cc: hs at denx.de; u-boot at lists.denx.de
Subject: Re: [PATCH] i2c:zynq: I2C multi-bus support on Zynq

On 09/24/2013 04:58 PM, Michael Burr wrote:
> Sorry, Michal
> 
> I only wrote that part to explain how I was able to test on the
> ZC702 board (in case somebody else should want to reproduce the 
> results).
> 
> I understand that you will sync the 'u-boot-xlnx' repo with mainline 
> at some time in the future, on your own schedule. I was not trying to 
> suggest that anything else be done right now.
> 
> Thanks again for your feedback,

I got this but keep in your mind that Heiko or others will apply this patch by git-am and your commit message will be the part of u-boot source code.
That's why there should be focus on problems which you are trying to solve.

If you need to point/explain something then write it below your SoB line and below "---" which ensure that git-am will remove these messages.

I would suggest to you to run git format-patch and then running git am < patch to see what will be there.

Thanks,
Michal

--
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/ Maintainer of Linux kernel - Xilinx Zynq ARM architecture Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform