[U-Boot] [PATCH v2 3/5] spi: ti_qspi: Add delay for successful bulk erase.

[Jagan Teki]

On Thu, Apr 3, 2014 at 5:22 PM, Tom Rini <trini at ti.com> wrote:
> From: "Poddar, Sourav" <sourav.poddar at ti.com>
>
> Bulk erase is not happening properly on dra7 due to erase timing constraints,
> add a delay so that erase timing constraints are properly met.
>
> Signed-off-by: Sourav Poddar <sourav.poddar at ti.com>
> Tested-by: Yebio Mesfin <ymesfin at ti.com>
> ---
>  drivers/spi/ti_qspi.c |    3 +++
>  1 file changed, 3 insertions(+)
>
> diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
> index dfa5d0c..c5d2245 100644
> --- a/drivers/spi/ti_qspi.c
> +++ b/drivers/spi/ti_qspi.c
> @@ -314,6 +314,9 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen, const void *dout,
>                         qslave->cmd |= QSPI_RD_SNGL;
>                         debug("rx cmd %08x dc %08x\n",
>                               qslave->cmd, qslave->dc);
> +                       #ifdef CONFIG_DRA7XX
> +                               udelay(500);
> +                       #endif
>                         writel(qslave->cmd, &qslave->base->cmd);
>                         status = readl(&qslave->base->status);
>                         timeout = QSPI_TIMEOUT;

Can't we fix this? discussed the same in previous version thread as well.

thanks!
-- 
Jagan.