[U-Boot] [PATCH] powerpc/mpc85xx: Remove QE firmware copy from NAND

[Prabhakar Kushwaha]

qe_init() does not use data copied from NAND. Thise code is not tested or
complied causing compilation error during NAND boot

So, remove QE firmware copy from NAND to ddr.

Signed-off-by: Prabhakar Kushwaha <prabhakar at freescale.com>
---
 arch/powerpc/cpu/mpc85xx/cpu_init.c |   13 -------------
 1 file changed, 13 deletions(-)

diff --git a/arch/powerpc/cpu/mpc85xx/cpu_init.c b/arch/powerpc/cpu/mpc85xx/cpu_init.c
index ea41ffc..36ef232 100644
--- a/arch/powerpc/cpu/mpc85xx/cpu_init.c
+++ b/arch/powerpc/cpu/mpc85xx/cpu_init.c
@@ -925,19 +925,6 @@ void cpu_secondary_init_r(void)
 #endif
 
 #ifdef CONFIG_QE
-#ifdef CONFIG_SYS_QE_FMAN_FW_IN_NAND
-	int ret;
-	size_t fw_length = CONFIG_SYS_QE_FMAN_FW_LENGTH;
-
-	/* load QE firmware from NAND flash to DDR first */
-	ret = nand_read(&nand_info[0], (loff_t)CONFIG_SYS_QE_FMAN_FW_IN_NAND,
-			&fw_length, (u_char *)CONFIG_SYS_QE_FW_ADDR);
-
-	if (ret && ret == -EUCLEAN) {
-		printf ("NAND read for QE firmware at offset %x failed %d\n",
-				CONFIG_SYS_QE_FMAN_FW_IN_NAND, ret);
-	}
-#endif
 	qe_init(qe_base);
 	qe_reset();
 #endif
-- 
1.7.9.5