[U-Boot] [PATCH] ARM: atmel: add sama5d3 Xplained board support

[Bo Shen]

Hi Wolfgang Denk,

On 02/09/2014 07:13 PM, Wolfgang Denk wrote:
> Dear Bo Shen,
>
> In message <1391932359-23520-1-git-send-email-voice.shen at atmel.com> you wrote:
>> Add sama5d3 Xplained board support which use Atmel SAMA5D36 SoC.
>> Now it supports boot from NAND flash and SD/MMC card.
>> Features support:
>>    - NAND flash
>>    - SD/MMC card
>>    - Two USB hosts
>>    - Ethernet (one GMAC, one EMAC)
>>
>> Signed-off-by: Bo Shen <voice.shen at atmel.com>
>> ---
>>
>>   board/atmel/sama5d3_xplained/Makefile           |  15 ++
>>   board/atmel/sama5d3_xplained/sama5d3_xplained.c | 130 +++++++++++++++
>>   boards.cfg                                      |   2 +
>>   include/configs/sama5d3_xplained.h              | 203 ++++++++++++++++++++++++
>>   4 files changed, 350 insertions(+)
>>   create mode 100644 board/atmel/sama5d3_xplained/Makefile
>>   create mode 100644 board/atmel/sama5d3_xplained/sama5d3_xplained.c
>>   create mode 100644 include/configs/sama5d3_xplained.h
>
> Can we please stop using the SoC name in the board config name?  The
> board name is just that: the name of the board.
>
> Please rename all sama5d3_xplained => xplained

This board name is "SAMA5D3 Xplained", while not "Xplained". Using two 
words as a total as this board name. For the source code, we use low 
case for these two words and connect with underscore. I think no need to 
rename.

> Thanks.
>
> Best regards,
>
> Wolfgang Denk
>

Best Regards,
Bo Shen