[U-Boot] [PATCH v1 2/3] omap3: fix pinmux for mcx board

[Stefano Babic]

New hardware version cannot recognize the SD-Card
because the SYS_NRESWARM, set as GPIO, does not
guarantee the required reset time.
Change the pin function back to enable the
SYS_NRESWARM signal driven by the SOC.

Signed-off-by: Stefano Babic <sbabic at denx.de>
---

 board/htkw/mcx/mcx.h |    2 --
 1 file changed, 2 deletions(-)

diff --git a/board/htkw/mcx/mcx.h b/board/htkw/mcx/mcx.h
index 703dbec..17c122c 100644
--- a/board/htkw/mcx/mcx.h
+++ b/board/htkw/mcx/mcx.h
@@ -325,8 +325,6 @@ const omap3_sysinfo sysinfo = {
 	MUX_VAL(CP(SYS_32K),		(IEN  | PTD | EN  | M4)) \
 	MUX_VAL(CP(SYS_CLKREQ),		(IEN  | PTD | DIS | M0)) \
 	MUX_VAL(CP(SYS_NIRQ),		(IEN  | PTD | EN  | M4)) \
-	MUX_VAL(CP(SYS_NRESWARM),	(IEN | PTU | DIS | M4)) \
-					/* SYS_nRESWARM */\
 	MUX_VAL(CP(SYS_BOOT0),		(IEN  | PTD | DIS | M4)) \
 	MUX_VAL(CP(SYS_BOOT1),		(IEN  | PTD | DIS | M4)) \
 	MUX_VAL(CP(SYS_BOOT2),		(IEN  | PTD | DIS | M4)) \
-- 
1.7.9.5