[U-Boot] [PATCH v3 08/13] ARM: HYP/non-sec: add the option for a second-stage monitor

[Marc Zyngier]

Allow the switch to a second stage secure monitor just before
switching to non-secure.

This allows a resident piece of firmware to be active once the
kernel has been entered (the u-boot monitor is dead anyway,
its pages being reused).

Signed-off-by: Marc Zyngier <marc.zyngier at arm.com>
---
 arch/arm/cpu/armv7/nonsec_virt.S | 13 +++++++++++--
 1 file changed, 11 insertions(+), 2 deletions(-)

diff --git a/arch/arm/cpu/armv7/nonsec_virt.S b/arch/arm/cpu/armv7/nonsec_virt.S
index 2a43e3c..745670e 100644
--- a/arch/arm/cpu/armv7/nonsec_virt.S
+++ b/arch/arm/cpu/armv7/nonsec_virt.S
@@ -44,10 +44,19 @@ _monitor_vectors:
  * ip: target PC
  */
 _secure_monitor:
+#ifdef CONFIG_ARMV7_PSCI
+	ldr	r5, =_psci_vectors		@ Switch to the next monitor
+	mcr	p15, 0, r5, c12, c0, 1
+	isb
+
+	@ Obtain a secure stack, and configure the PSCI backend
+	bl	psci_arch_init
+#endif
+
 	mrc	p15, 0, r5, c1, c1, 0		@ read SCR
-	bic	r5, r5, #0x4e			@ clear IRQ, FIQ, EA, nET bits
+	bic	r5, r5, #0x4a			@ clear IRQ, EA, nET bits
 	orr	r5, r5, #0x31			@ enable NS, AW, FW bits
-
+						@ FIQ preserved for secure mode
 	mov	r6, #SVC_MODE			@ default mode is SVC
 	is_cpu_virt_capable r4
 #ifdef CONFIG_ARMV7_VIRT
-- 
1.8.5.1