[U-Boot] [PATCH v2 1/2] nand/denali: Adding Denali NAND driver support

Chin Liang See clsee at altera.com
Thu Feb 27 22:02:33 CET 2014


Hi Masahiro,

On Thu, 2014-02-27 at 23:35 +0900, Masahiro Yamada wrote:
> Hello Chin,
> 
> 
> > +
> > +	nand->ecc.mode = NAND_ECC_HW;
> > +	nand->ecc.size = CONFIG_NAND_DENALI_ECC_SIZE;
> > +	nand->ecc.read_oob = denali_read_oob;
> > +	nand->ecc.write_oob = denali_write_oob;
> > +	nand->ecc.read_page = denali_read_page;
> > +	nand->ecc.read_page_raw = denali_read_page_raw;
> > +	nand->ecc.write_page = denali_write_page;
> > +	nand->ecc.write_page_raw = denali_write_page_raw;
> > +#ifdef CONFIG_SYS_NAND_15BIT_HW_ECC_OOBFIRST
> > +	/* 15bit ECC */
> > +	nand->ecc.bytes = 26;
> > +	nand->ecc.layout = &nand_15bit_oob;
> > +#else	/* 8bit ECC */
> > +	nand->ecc.bytes = 14;
> > +	nand->ecc.layout = &nand_8bit_oob;
> > +#endif
> > +	nand->ecc.calculate = denali_ecc_calculate;
> > +	nand->ecc.correct  = denali_ecc_correct;
> > +	nand->ecc.hwctl  = denali_ecc_hwctl;
> 
> You set nand->ecc.mode = NAND_ECC_HW,
> but it looks like you don't set  nand->ecc.strength.
> 
> So, I think initialization will fail in nand_scan_tail() function.
> 
> Here,
> 
>                 if (mtd->writesize >= chip->ecc.size) {
>                         if (!chip->ecc.strength) {
>                                 pr_warn("Driver must set ecc.strength when using hardware ECC\n");
>                                 BUG();
>                         }
>                         break;
> 
> 
> 
> Where do you set nand->ecc.strength?

I believe this is only applicable for NAND_ECC_HW_SYNDROME mode. We are
using the NAND_ECC_HW (without the syndrome). Wonder you hit error
during run?

Chin Liang

> 
> 
> 
> 
> Best Regards
> Masahiro Yamada
> 
> 




More information about the U-Boot mailing list