[U-Boot] [PATCH 1/1] ARM: dra7_evm: read mac address properly from e-fuse

[Mugunthan V N]

Byte offset of Ethernet mac address read from e-fuse are wrong so DHCP is
not working on some boards, modifying the offset to read properly.

Signed-off-by: Mugunthan V N <mugunthanvnm at ti.com>
---
 board/ti/dra7xx/evm.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/board/ti/dra7xx/evm.c b/board/ti/dra7xx/evm.c
index 9ae88c5..1b60b8f 100644
--- a/board/ti/dra7xx/evm.c
+++ b/board/ti/dra7xx/evm.c
@@ -202,12 +202,12 @@ int board_eth_init(bd_t *bis)
 	/* try reading mac address from efuse */
 	mac_lo = readl((*ctrl)->control_core_mac_id_0_lo);
 	mac_hi = readl((*ctrl)->control_core_mac_id_0_hi);
-	mac_addr[0] = mac_hi & 0xFF;
+	mac_addr[0] = (mac_hi & 0xFF0000) >> 16;
 	mac_addr[1] = (mac_hi & 0xFF00) >> 8;
-	mac_addr[2] = (mac_hi & 0xFF0000) >> 16;
-	mac_addr[3] = mac_lo & 0xFF;
+	mac_addr[2] = mac_hi & 0xFF;
+	mac_addr[3] = (mac_lo & 0xFF0000) >> 16;
 	mac_addr[4] = (mac_lo & 0xFF00) >> 8;
-	mac_addr[5] = (mac_lo & 0xFF0000) >> 16;
+	mac_addr[5] = mac_lo & 0xFF;
 
 	if (!getenv("ethaddr")) {
 		printf("<ethaddr> not set. Validating first E-fuse MAC\n");
-- 
1.8.5.2.192.g7794a68