[U-Boot] [PATCH v4 00/29] zynq: More boards support

[Jagan Teki]

Hi Albert,

On Wed, Jan 8, 2014 at 10:44 PM, Albert ARIBAUD
<albert.u.boot at aribaud.net> wrote:
> Hi Jagannadha,
>
> On Wed, 8 Jan 2014 15:53:07 +0530, Jagannadha Sutradharudu Teki
> <jagannadha.sutradharudu-teki at xilinx.com> wrote:
>
>> These changes are from u-boot-xlnx.git repo from git.xilinx.com
>> and in addition of basic fdt support. This repo is well tested
>> on xilinx zynq platform, hence pushing the same on upstream.
>>
>> Excluded qspi and nand changes from previous series.
>>
>> Please note that all this series available in u-boot-spi.git/master-xlnx
>> repo.
>>
>> --
>> Thanks,
>> Jagan.
>>
>> Changes for v4:
>>       - rebase to master
>>       - Removed CONFIG_SYS_NO_FLASH in zynq-common.h
>
> As the series was rebased tu u-boot/master, not u-boot-arm/master,
> all patches adding board support failed to apply properly due to
> boards.cfg differences.
Yes - I saw this i'll rebase your u-boot-arm/master then.

>
> I did resolve these manually, but at build-test time, all Zynq boards
> failed with "Makefile:11: *** Please define CONFIG_DEFAULT_DEVICE_TREE
> in your board header file.  Stop." -- and were the only ones to do so.
Actually build will successful when you give the dts at runtime while
building u-boot like Linux style.
$ make DEVICE_TREE=<dts_file_name>
ex: make DEVICE_TREE=zynq-zc702

This is the reason I am not defining this on individual pre-board configs.
I guess this could be fine, please comment.

-- 
Thanks,
Jagan.