[U-Boot] [PATCH] mx6sabred: Add PFUZE100 PMIC support

[Fabio Estevam]

On Mon, May 5, 2014 at 12:56 PM, Fabio Estevam <festevam at gmail.com> wrote:
> On Mon, May 5, 2014 at 12:32 PM, Tim Harvey <tharvey at gateworks.com> wrote:
>
>> Hi Fabio,
>>
>> Yes, I think Stefano is correct in that power_init_board() is the
>> right place to put pmic init. He asked me to do that to my recent
>> series as well and it worked fine. Note that in that series I do have
>> a patch that will rename pmic_init() for the PFUZE100 to
>> power_pfuze100_init() [1]. I'm hoping that will make it in soon.
>
> Thanks, Tim.
>
> Stefano,
>
> It seems that I need to wait for Tim's series to be applied, otherwise
> there will be a build breakage.

In the meantime I converted the current patch to using
power_init_board() instead, but this causes problems:

=> pmic list
PMIC devices:
name: PFUZE100_PMIC bus: I2C_1
=> pmic PFUZE100_PMIC dump
PMIC: PFUZE100_PMIC
wait_for_sr_state: failed sr=81 cr=a0 state=2020
i2c_init_transfer: failed for chip 0x8 retry=0
wait_for_sr_state: failed sr=81 cr=a0 state=2020
i2c_init_transfer: failed for chip 0x8 retry=1
wait_for_sr_state: failed sr=81 cr=a0 state=2020
i2c_init_transfer: failed for chip 0x8 retry=2
i2c_init_transfer: give up i2c_regs=021a0000
PMIC: Registers dump failed

With the previous misc_init_r() approach the 'dump' command worked correctly.

Any suggestions?

Regards,

Fabio Estevam