[U-Boot] [PATCH 1/3] usb: tegra: fix PHY selection code

Stefan Agner stefan at agner.ch
Mon May 12 14:34:03 CEST 2014


Am 2014-04-30 23:09, schrieb Stephen Warren:
> From: Stephen Warren <swarren at nvidia.com>
> 
> The TRM for Tegra30 and later all state that USBMODE_CM_HC must be set
> before writing to hostpc1_devlc to select which PHY to use for a USB
> controller. However, neither init_{utmi,ulpi}_usb_controller() do this
> today, so the register writes they perform for PHY selection do not
> work.
> 
> For the UTMI case, this was hacked around in commit 7e44d9320ed4 "ARM:
> Tegra: USB: EHCI: Add support for Tegra30/Tegra114" by adding code to
> ehci_hcd_init() which sets USBMODE_CM_HC and duplicates the PHY
> selection register write. This code doesn't cover the ULPI case, so I
> wouldn't be surprised if ULPI doesn't work with the current code, unless
> the ordering requirement only ends up being an issue in HW for UTMI not
> ULPI.

On Toradex Colibri T30, all USB, including USB2, are using the UTMI phy.
I successfully tested this patchset on the Colibri T30 module (not yet
in mainline U-Boot).

Tested-by <stefan at agner.ch>

--
Stefan


More information about the U-Boot mailing list