[U-Boot] spi_flash_probe returns zero idcodes and hangs
Amit Mahadik
amitmahadik35 at yahoo.com
Sun May 25 06:31:47 CEST 2014
Hello Sir,
I will definetely try to trace the transactions.
------------------------------
On Sun 25 May, 2014 12:52 AM IST Jon Loeliger wrote:
>Amit,
>
>If you can, place a SPI protocol analyzer on the bus and trace its transactions.
>
>I recently debugged a similar symptom and discovered that I was not driving
>the Tx FIFO consistently enough to maintain the appearance of a single
>transaction on the ID request to the flash.
>
>How is your SPI device (flash, right?) being selected? If via a GPIO, are you
>sure you are driving it properly? If it is directly using a
>controller's slave-select
>line, you may need to ensure a full Tx FIFO for both the write and response.
>
>HTH,
>jdl
>
>
>On Sat, May 24, 2014 at 12:15 PM, Jagan Teki <jagannadh.teki at gmail.com> wrote:
> On Sat, May 24, 2014 at 10:27 PM, Amit Mahadik <amitmahadik35 at yahoo.com> wrote:
> Hello All,
> I am using a custom ARM based development board running u-boot from PNOR memory. However, it does not have support for the Micron SPI flash memory (N25Q064A). I have added support for the micron memory in drivers/mtd/spi/stmicro.c file and included the flag CONFIG_SPI_FLASH_STMICRO in the config file and recompiled the u-boot source source. Then, ran it directly through RAM memory.
> The new u-boot ran from RAM. Now when I run sf probe 0 command I get the following output
> Got Idcodes 000000: 00 00 00 00 and the code hangs after this.
>
> Looks like your driver itself is not returning any proper idcode.
>
> What id details you added - I think you're using old u-boot no stmicro.c
> in current u-boot, please re-base to master and try.
>
> thanks!
> --
> Jagan.
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
More information about the U-Boot
mailing list