[U-Boot] [PATCH v3 3/3] imx:mx6slevk add board level support for usb

[Peng Fan]

在 11/7/2014 7:10 PM, Marek Vasut 写道:
> On Friday, November 07, 2014 at 12:08:03 PM, Peng Fan wrote:
>> 在 11/7/2014 4:26 PM, Marek Vasut 写道:
>>> On Friday, November 07, 2014 at 02:08:14 AM, Peng Fan wrote:
>>>> Add pinmux settings, implement board_ehci_hcd_init, board_usb_phy_mode
>>>>
>>>> There are two usb port on mx6slevk board:
>>>> 1. otg port
>>>> 2. host port
>>>> The following are the connection between usb controller and board usb
>>>> interface, host port has not ID pin set:
>>>> otg1 core <---> board otg port
>>>> otg2 core <---> board host port
>>>> In order to make host port work, board_usb_phy_mode return 0 to let
>>>> ehci-mx6.c driver decide otg2 core to works in host mode.
>>>>
>>>> Signed-off-by: Peng Fan <Peng.Fan at freescale.com>
>>>> Signed-off-by: Ye Li <B37916 at freescale.com>
>>>> ---
>>>
>>> [...]
>>>
>>>> @@ -150,6 +151,63 @@ static int setup_fec(void)
>>>>
>>>>    }
>>>>    #endif
>>>>
>>>> +#ifdef CONFIG_USB_EHCI_MX6
>>>> +#define USB_OTHERREGS_OFFSET	0x800
>>>> +#define USBPHY_CTRL		0x30
>>>> +#define UCTRL_PWR_POL		(1 << 9)
>>>> +#define USBPHY_CTRL_OTG_ID	0x08000000
>>>
>>> This looks like an duplication. Aren't those bits defined somewhere in
>>> generic code already ?
>>
>> If this way 'int board_usb_phy_mode(int port, enum usb_init_type *type)'
>> can be accpeted, these bits are not needed and I'll move these bits in
>> the seperate PHY register struct access patch. Anyway, after the board
>> level usb support patch.
>
> What about abstracting that stuff into a function which returns the PHY's
> idea of the current mode instead. That way, you can determine the PHY's
> idea of the mode from both board code and the driver code.
>
struct phy register is good, but I prefer not to include this in board 
level code, see my reply in this patch "usb:ehci-mx6 add 
board_usb_phy_mode function" just as "board_ehci_power" and 
"board_ehci_hcd_init" do. I think it is good to make it a seperate patch.
> Best regards,
> Marek Vasut
>
Regards,
Peng.