[U-Boot] [PATCH v2 0/8] *** iMX6 SabreSD SPL Support ***

[John Tobias]

This patch is for SPL support for iMX6 SabreSD. The said
patches has been tested to work on SD2 and SD3 port of the
said board.

After applying the following patches, it will produces
SPL and u-boot.img binary images. You should run the
two commands below to store it in your SD or eMMC.

sudo dd if=SPL of=/dev/xxx bs=1K seek=1; sync
sudo dd if=u-boot.img of=/dev/xxx bs=1K seek=69

Changes:
Merged the SPL support into the main board file
Remove the compilation warmings

John Tobias (8):
  mmc: add spl_board_mmc_init
  mmc: imx6: call spl_board_mmc_init
  imx6: add spl on board configuration
  imx6: add some flexibility for defining macros
  imx6: add spl on board configuration
  imx6: SPL support for iMX6 SabreSD
  imx6: add data configuration file for SPL
  kconfig: imx6: add SUPPORT_SPL

 arch/arm/Kconfig                              |   1 +
 board/freescale/mx6sabresd/mx6sabresd.c       | 216 ++++++++++++++++++++++++++
 board/freescale/mx6sabresd/mx6sabresd_spl.cfg |  54 +++++++
 configs/mx6qsabresd_defconfig                 |   7 +-
 drivers/mmc/mmc.c                             |   5 +-
 include/configs/imx6_spl.h                    |   4 +
 include/configs/mx6sabresd.h                  |   7 +
 include/mmc.h                                 |   4 +-
 8 files changed, 293 insertions(+), 5 deletions(-)
 create mode 100644 board/freescale/mx6sabresd/mx6sabresd_spl.cfg

-- 
1.9.1