[U-Boot] [PATCH 2/2] mtd: denali: set some registers after nand_scan_ident()

[Masahiro Yamada]

Some but not all of implementations of the Denali NAND controller
have hardware circuits to detect the device parameters such as
page_size, erase_size, etc.  Even on those SoCs with such hardware
supported, the hardware is known to detect wrong parameters for some
nasty (almost buggy) NAND devices.  The device parameters detected
during nand_scan_ident() are more trustworthy.

This commit sets some hardware registers to mtd->pagesize,
mtd->oobsize, etc. in the code between nand_scan_ident() and
nand_scan_tail().

Signed-off-by: Masahiro Yamada <yamada.m at jp.panasonic.com>
Cc: Scott Wood <scottwood at freescale.com>
Cc: Chin Liang See <clsee at altera.com>
---

 drivers/mtd/nand/denali.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c
index a9838d8..a2b346e 100644
--- a/drivers/mtd/nand/denali.c
+++ b/drivers/mtd/nand/denali.c
@@ -1209,6 +1209,17 @@ static int denali_init(struct denali_nand_info *denali)
 	nand_oob.eccbytes = denali->nand.ecc.bytes;
 	denali->nand.ecc.layout = &nand_oob;
 
+	writel(denali->mtd->erasesize / denali->mtd->writesize,
+	       denali->flash_reg + PAGES_PER_BLOCK);
+	writel(denali->nand.options & NAND_BUSWIDTH_16 ? 1 : 0,
+	       denali->flash_reg + DEVICE_WIDTH);
+	writel(denali->mtd->writesize,
+	       denali->flash_reg + DEVICE_MAIN_AREA_SIZE);
+	writel(denali->mtd->oobsize,
+	       denali->flash_reg + DEVICE_SPARE_AREA_SIZE);
+	if (readl(denali->flash_reg + DEVICES_CONNECTED) == 0)
+		writel(1, denali->flash_reg + DEVICES_CONNECTED);
+
 	/* override the default operations */
 	denali->nand.ecc.read_page = denali_read_page;
 	denali->nand.ecc.read_page_raw = denali_read_page_raw;
-- 
1.9.1