[U-Boot] [PATCH v6 0/5] iMX6 SabreSD SPL Support

[John Tobias]

Hi Fabio,

Thanks for the info.

Regards,

john

On Wed, Nov 12, 2014 at 10:19 AM, Fabio Estevam <festevam at gmail.com> wrote:
> Hi John,
>
> On Wed, Nov 12, 2014 at 3:14 PM, John Tobias <john.tobias.ph at gmail.com> wrote:
>> This patch is for SPL support for iMX6 SabreSD. The said
>> patches has been tested to work on SD2 and SD3 port of the
>> said board.
>>
>> After applying the following patches, it will produces
>> SPL and u-boot.img binary images. You should run the
>> two commands below to store it in your SD or eMMC.
>>
>> sudo dd if=SPL of=/dev/xxx bs=1K seek=1; sync
>> sudo dd if=u-boot.img of=/dev/xxx bs=1K seek=69
>
> Thanks for working on this of for your patience.
>
> It worked fine here:
>
> Tested-by: Fabio Estevam <fabio.estevam at freescale.com>
> Reviewed-by: Fabio Estevam <fabio.estevam at freescale.com>