[U-Boot] [PATCH v7 0/5] iMX6 SabreSD SPL Support

[Fabio Estevam]

On Wed, Nov 12, 2014 at 8:27 PM, John Tobias <john.tobias.ph at gmail.com> wrote:
> This patch is for SPL support for iMX6 SabreSD. The said
> patches has been tested to work on SD2 and SD3 port of the
> said board. It tested the non-spl version of uboot as well.
>
> After applying the following patches, it will produces
> SPL and u-boot.img binary images. You should run the
> two commands below to store it in your SD or eMMC.
>
> sudo dd if=SPL of=/dev/xxx bs=1K seek=1; sync
> sudo dd if=u-boot.img of=/dev/xxx bs=1K seek=69
>
> Changes (v2):
> Merged the SPL support into the main board file
> Remove the compilation warmings
>
> Changes (v3):
> Removed sp and gd
> Use imx_ddr_size to set the ram_size
>
> Changes (v4):
> Add a separate board configuration file to enable SPL
> (mx6sabresd_spl_defconfig).
>
> Mapped DCD data to mx6_mmdc_calibration, mx6dq_iomux_grp_regs,
> mx6dq_iomux_ddr_regs and mx6_ddr3_cfg data structures.
>
> Read 11 and 12 bits of BOOT_CFG register to actually determine
> the active mmc port.
>
> Changes (v5):
> Use the default CONFIG_SPL_STACK
> Add a macro #ifndef for CONFIG_SYS_TEXT_BASE to avoid
> compilation warning.
>
> Changes (v6):
> Use board_mmc_init for spl mmc initialization instead of
> adding spl_board_mmc_init function
>
> Changes (v7):
> Corrected the chip select value and now the DRAM showing
> a correct 1 GiB.

Yes, I confirm it detects the correct DRAM size now.

For the whole series:

Tested-by: Fabio Estevam <fabio.estevam at freescale.com>
Reviewed-by: Fabio Estevam <fabio.estevam at freescale.com>

Thanks, John!