[U-Boot] [PATCH] ot1200: add support for EHCI

Stefano Babic sbabic at denx.de
Thu Nov 13 16:34:42 CET 2014


On 10/11/2014 14:35, Christian Gmeiner wrote:
> U-Boot 2014.10-17457-g0b23780-dirty (Nov 10 2014 - 11:41:04)
> 
> CPU:   Freescale i.MX6D rev1.2 at 792 MHz
> Reset cause: WDOG
> Board: ot1200
> I2C:   ready
> DRAM:  1 GiB
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1
> SF: Detected M25P16 with page size 256 Bytes, erase size 64 KiB, total 2 MiB
> In:    serial
> Out:   serial
> Err:   serial
> Net:   using phy at 0
> FEC [PRIME]
> Hit any key to stop autoboot:  0
> => usb start
> (Re)start USB...
> USB0:   Port not available.
> USB1:   USB EHCI 1.00
> scanning bus 1 for devices... 4 USB Device(s) found
> => usb tree
> USB device tree:
>   1  Hub (480 Mb/s, 0mA)
>   |  u-boot EHCI Host Controller
>   |
>   +-2  Hub (480 Mb/s, 2mA)
>     |
>     +-3  Mass Storage (480 Mb/s, 80mA)
>     |    USBest Technology USB Mass Storage Device 0000000000028B
>     |
>     +-4  Vendor specific (480 Mb/s, 2mA)
> 
> =>
> 
> Signed-off-by: Christian Gmeiner <christian.gmeiner at gmail.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic



-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================


More information about the U-Boot mailing list