[U-Boot] [PATCH v6 4/4] mx6: thermal: Enable thermal sensor for mx6 sabre boards.

[nitin.garg at freescale.com]

From: Nitin Garg <nitin.garg at freescale.com>

Add CONFIG_IMX6_THERMAL to mx6sabre_common.h file. Since
thermal driver depends on ocotp, make sure to enable
CONFIG_MXC_OCOTP when CONFIG_IMX6_THERMAL is slected.

Signed-off-by: Nitin Garg <nitin.garg at freescale.com>
---
 include/configs/mx6sabre_common.h |    3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/include/configs/mx6sabre_common.h b/include/configs/mx6sabre_common.h
index c81e9e9..7db06fe 100644
--- a/include/configs/mx6sabre_common.h
+++ b/include/configs/mx6sabre_common.h
@@ -24,6 +24,7 @@
 #define CONFIG_SETUP_MEMORY_TAGS
 #define CONFIG_INITRD_TAG
 #define CONFIG_REVISION_TAG
+#define CONFIG_IMX6_THERMAL
 
 #define CONFIG_SYS_GENERIC_BOARD
 
@@ -37,7 +38,7 @@
 #define CONFIG_MXC_UART
 
 #define CONFIG_CMD_FUSE
-#ifdef CONFIG_CMD_FUSE
+#if defined(CONFIG_CMD_FUSE) || defined(CONFIG_IMX6_THERMAL)
 #define CONFIG_MXC_OCOTP
 #endif
 
-- 
1.7.9.5