[U-Boot] [PATCH] imx:mx6sxsabresd fix pfuz probe failed

[Stefano Babic]

On 31/10/2014 04:08, Peng Fan wrote:
> The PFUZ probe failed with the following msg:
> " wait_for_sr_state: failed sr=81 cr=a0 state=2020
>   i2c_init_transfer: failed for chip 0x8 retry=0
>   wait_for_sr_state: failed sr=81 cr=a0 state=2020
>   i2c_init_transfer: failed for chip 0x8 retry=1
>   wait_for_sr_state: failed sr=81 cr=a0 state=2020
>   i2c_init_transfer: failed for chip 0x8 retry=2
>   i2c_init_transfer: give up i2c_regs=021a0000
>   Can't find PMIC:PFUZE100 "
> 
> board_early_init_f is too early to call i2c related setting, because
> init_func_i2c is called after board_early_init_f being invoked. Thus
> move setup_i2c into board_init.
> 
> Also PFUZ is connected to I2C bus 0, so change "1" -> "0".
> 
> Using this patch PFUZ can be correctly probed:
> "PMIC:  PFUZE100 ID=0x11"
> 
> Signed-off-by: Peng Fan <Peng.Fan at freescale.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic


-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================