[U-Boot] [PATCH 3/3] mx6qsabreauto: Add parallel NOR flash support

Stefano Babic sbabic at denx.de
Thu Nov 20 10:38:47 CET 2014


On 14/11/2014 14:27, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.estevam at freescale.com>
> 
> mx6sabreauto boards come with 32 MiB of parallel NOR flash.
> 
> Add support for it:
> 
> U-Boot 2015.01-rc1-18107-g1543636-dirty (Nov 14 2014 - 11:11:04)                
>                                                                                 
> CPU:   Freescale i.MX6Q rev1.2 at 792 MHz                                       
> Reset cause: POR                                                                
> Board: MX6Q-Sabreauto revA                                                      
> I2C:   ready                                                                    
> DRAM:  2 GiB                                                                    
> Flash: 32 MiB                                                                   
> NAND:  0 MiB                                                                    
> 
> Due to pin conflict with I2C3, only define configure I2C3 IOMUX when flash is
> not used.
> 
> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================


More information about the U-Boot mailing list