[U-Boot] [PATCH] tbs2910: Fix error handling in board_mmc_init()

[Soeren Moch]

When an invalid USDHC port is passed we should return -EINVAL instead of 0.
Also, return the error immediately on fsl_esdhc_initialize() failure.

Based on similar patches by Fabio Estevam for mx6sabresd, mx53loco, wandboard

Signed-off-by: Soeren Moch <smoch at web.de>
--
Cc: Stefano Babic <sbabic at denx.de>
Cc: Fabio Estevam <festevam at gmail.com>
---
 board/tbs/tbs2910/tbs2910.c | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)

diff --git a/board/tbs/tbs2910/tbs2910.c b/board/tbs/tbs2910/tbs2910.c
index daf8ff4..dfa430e 100644
--- a/board/tbs/tbs2910/tbs2910.c
+++ b/board/tbs/tbs2910/tbs2910.c
@@ -219,15 +219,13 @@ int board_mmc_getcd(struct mmc *mmc)
 
 int board_mmc_init(bd_t *bis)
 {
-	s32 status = 0;
-	int i;
-
 	/*
 	 * (U-boot device node)    (Physical Port)
 	 * mmc0                    SD2
 	 * mmc1                    SD3
 	 * mmc2                    eMMC
 	 */
+	int i, ret;
 	for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++) {
 		switch (i) {
 		case 0:
@@ -251,12 +249,13 @@ int board_mmc_init(bd_t *bis)
 			printf("Warning: you configured more USDHC controllers"
 			       "(%d) then supported by the board (%d)\n",
 			       i + 1, CONFIG_SYS_FSL_USDHC_NUM);
-			return status;
+			return -EINVAL;
 		}
-
-		status |= fsl_esdhc_initialize(bis, &usdhc_cfg[i]);
+		ret = fsl_esdhc_initialize(bis, &usdhc_cfg[i]);
+		if (ret)
+			return ret;
 	}
-	return status;
+	return 0;
 }
 #endif /* CONFIG_FSL_ESDHC */
 
-- 
1.9.1