[U-Boot] help on using buildman

[York Sun]

On 11/20/2014 11:51 AM, Simon Glass wrote:
>>
>> Nothing more than that. Where shall I look for ARCH?
> 
> That doesn't look like a full build to me. The 'err' file may have
> more clues. You could try without '--force-build --force-reconfig'
> perhaps.
> 

No, it failed. The err file has this

$ cat err
make[1]: *** No rule to make target `../arch//cpu/u-boot.lds', needed by
`u-boot.lds'.  Stop.
make[1]: *** Waiting for unfinished jobs....
make: *** [sub-make] Error 2


>>
>> If I build for board T4240QDS, it has error on most but not all. T4240QDS
>> T4240QDS_SRIO_PCIE_BOOT T4240QDS_SECURE_BOOT failed, but T4240QDS_NAND didn't.
> 
> It's a bit of a mystery. How about adding V=1 in your make flags in ~/.buildman:
> 

I think the key is to configure it, not build it. With the failure case, it
doesn't build. I am thinking to find the equivalent to "make ARCH=power ...".
How to dump that?

York