[U-Boot] [PATCH 0/5] PL01x: baudrate & line control fixes

[vikasm]

Hello Simon,

On 11/24/2014 07:51 PM, Simon Glass wrote:
> Hi Vikas,
>
> On 24 November 2014 at 17:40, vikasm <vikas.manocha at st.com> wrote:
>> Hi Simon,
>>
>>
>> On 11/24/2014 07:51 AM, Simon Glass wrote:
>>> Hi Vikas,
>>>
>>> On 18 November 2014 at 11:59, vikasm <vikas.manocha at st.com> wrote:
>>>> Thanks Simon,
>>>>
>>>>
>>>> On 11/17/2014 09:30 PM, Simon Glass wrote:
>>>>> Hi Vikas,
>>>>>
>>>>> On 18 November 2014 00:17, Vikas Manocha <vikas.manocha at st.com> wrote:
>>>>>> This patchset fixes the pl01x driver esp for pl011 baudrate & line
>>>>>> control.
>>>>>>
>>>>>> Vikas Manocha (5):
>>>>>>      serial: pl01x: pass pl01x_type to set baudrate
>>>>>>      serial: pl01x: fix pl011 baud rate configuration
>>>>>>      serial: pl01x: move all line control at same place
>>>>>>      serial: pl01x: disable as per type of pl01x
>>>>>>      serial: pl01x: avoid pl01x type check two times
>>>>>>
>>>>>>     drivers/serial/serial_pl01x.c |   46
>>>>>> +++++++++++++++++++++--------------------
>>>>>>     1 file changed, 24 insertions(+), 22 deletions(-)
>>>>> Great to see this series. If you have not tested on p1010 I can do
>>>>> this in a week or so (am travelling). At least a few of these looks
>>>>> like bug fixes to my recent refactor so I could bring them through the
>>>>> DM tree if no one else picks them up.
>>>>
>>>> I was able to test it only for pl011, don't have any board with pl010.
>>> Sadly I was wrong, I only have pl011 also. It makes me wonder how it
>>> worked so nicely for me without your patches.
>> Please find below the possible explanation for all patches:
>>
>> serial: pl01x: pass pl01x_type to set baudrate
>> - This patch only affect if DM is not defined.
>> If you are using driver model for pl011, pl011 will work without this patch.
>>
>> serial: pl01x: fix pl011 baud rate configuration
>> - If pl011 is already configured to correct baudrate or LCR register is
>> being written later.
>>
>> serial: pl01x: move all line control at same place
>> - this patch does not affect the functionality.
>>
>> serial: pl01x: disable as per type of pl01x
>> - pl011 might work without disabling it properly at start.
>> pl010 control register(disable bit) location is reserved in case of pl011.
>>
>> serial: pl01x: avoid pl01x type check two times
>> - does not affect the functionality.
> I didn't mean for you to go to that much trouble, but thank you.

Not a problem, i was also curious to know it.

>
> Raspberry Pi is running without driver model (I tested it both ways)
> so I guess I'm just lucky (or actually unlucky since I might have
> noticed these problems).

just guessing... (don't want to bother you....don't reply if is not the 
case)
could it be possible uart is already initialized before u-boot like in 
xloader if it exists for Raspberry....

>
> When Stephen ACKs my Raspberry Pi driver rmodel series then I'll pull
> this series in to DM.

ok.

>
> Regards,
> Simon

Regards,
Vikas