[U-Boot] [PATCH] mmc: set correct block size value in bfin sdh driver

[Pantelis Antoniou]

Hi Sonic,

On Aug 6, 2014, at 1:14 PM, Sonic Zhang <sonic.adi at gmail.com> wrote:

> From: Sonic Zhang <sonic.zhang at analog.com>
> 
> Wait data transfer till the data end bit other than the data block end
> bit is set.
> 
> Signed-off-by: Sonic Zhang <sonic.zhang at analog.com>
> ---
> 
> drivers/mmc/bfin_sdh.c | 7 ++++---
> 1 file changed, 4 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/mmc/bfin_sdh.c b/drivers/mmc/bfin_sdh.c
> index bcd6a3e..9bdfbbc 100644
> --- a/drivers/mmc/bfin_sdh.c
> +++ b/drivers/mmc/bfin_sdh.c
> @@ -138,9 +138,9 @@ static int sdh_setup_data(struct mmc *mmc, struct mmc_data *data)
> 	if (data->flags & MMC_DATA_WRITE)
> 		return UNUSABLE_ERR;
> #ifndef RSI_BLKSZ
> -	data_ctl |= ((ffs(data_size) - 1) << 4);
> +	data_ctl |= ((ffs(data->blocksize) - 1) << 4);
> #else
> -	bfin_write_SDH_BLK_SIZE(data_size);
> +	bfin_write_SDH_BLK_SIZE(data->blocksize);
> #endif
> 	data_ctl |= DTX_DIR;
> 	bfin_write_SDH_DATA_CTL(data_ctl);
> @@ -189,7 +189,8 @@ static int bfin_sdh_request(struct mmc *mmc, struct mmc_cmd *cmd,
> 		do {
> 			udelay(1);
> 			status = bfin_read_SDH_STATUS();
> -		} while (!(status & (DAT_BLK_END | DAT_END | DAT_TIME_OUT | DAT_CRC_FAIL | RX_OVERRUN)));
> +		} while (!(status & (DAT_END | DAT_TIME_OUT | DAT_CRC_FAIL |
> +			 RX_OVERRUN)));
> 
> 		if (status & DAT_TIME_OUT) {
> 			bfin_write_SDH_STATUS_CLR(DAT_TIMEOUT_STAT);
> -- 
> 1.8.2.3
> 


Applied, thanks.

— Pantelis