[U-Boot] [PATCH 17/32] nitrogen6x: display: add wvga-lvds panel

[Eric Nelson]

Add support for WVGA (800x480) panels using VESA GTF timings over
LVDS.

No auto-detection is supported, so you must configure this panel
manually through the 'panel' environment variable:

        U-Boot > setenv panel svga
        U-Boot > saveenv && reset

Signed-off-by: Eric Nelson <eric.nelson at boundarydevices.com>
---
 board/boundary/nitrogen6x/nitrogen6x.c | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/board/boundary/nitrogen6x/nitrogen6x.c b/board/boundary/nitrogen6x/nitrogen6x.c
index c91e0c4..115ee81 100644
--- a/board/boundary/nitrogen6x/nitrogen6x.c
+++ b/board/boundary/nitrogen6x/nitrogen6x.c
@@ -680,6 +680,26 @@ struct display_info_t const displays[] = {{
 		.sync           = FB_SYNC_EXT,
 		.vmode          = FB_VMODE_NONINTERLACED
 } }, {
+	.bus	= 0,
+	.addr	= 0,
+	.pixfmt	= IPU_PIX_FMT_LVDS666,
+	.detect	= 0,
+	.enable	= enable_lvds,
+	.mode	= {
+		.name           = "wvga-lvds",
+		.refresh        = 57,
+		.xres           = 800,
+		.yres           = 480,
+		.pixclock       = 15385,
+		.left_margin    = 220,
+		.right_margin   = 40,
+		.upper_margin   = 21,
+		.lower_margin   = 7,
+		.hsync_len      = 60,
+		.vsync_len      = 10,
+		.sync           = FB_SYNC_EXT,
+		.vmode          = FB_VMODE_NONINTERLACED
+} }, {
 	.bus	= 2,
 	.addr	= 0x48,
 	.pixfmt	= IPU_PIX_FMT_RGB666,
-- 
1.9.1