[U-Boot] [PATCH 0/2 v3] arm: socfpga: Add Cadence QSPI support

[Marek Vasut]

On Wednesday, October 01, 2014 at 05:13:07 PM, Stefan Roese wrote:
> Hi!
> 
> So this is my 3rd posting regarding the Candence SPI driver on SoCFPGA.
> 
> The current status is, that SPI NOR flash works now without problems.
> And dcache is still enabled. The previous disabling was not needed.
> And only caused problems while booting into Linux. No cache flush or
> invalidate is needed. As no DMA engine is involved in this transfer.
> 
> The "solution" I used to get SPI NOR flash support working now
> is implemented in patch 0004 (still marked as RFC). Here a software reset
> is issued on the Micron N25Q256A SPI NOR flash. This seems to solve all
> problems and reading / writing to the SPI NOR flash seems to work now
> just fine. Even rebooting via pushbutton-reset or reset command works.
> 
> I think this version is now in much better state. Thats why I removed
> the WIP from the subject lines.
> 
> Again, this is tested on the EBV SoCrates eval board.

I picked this up into u-boot-socfpga:topic/drivers/qspi-wip-20141003 so it 
doesn't get lost. Also, they are updated to use the latest socfpga stuff,
esp. since the socfpga_cyclone5_common.h was renamed to socfpga_common.h .

Best regards,
Marek Vasut