[U-Boot] [PATCH v6 2/7] mtd: denali: add Denali NAND driver for SPL

[Masahiro YAMADA]

2014-10-03 19:21 GMT+09:00 Masahiro Yamada <yamada.m at jp.panasonic.com>:
> The SPL-mode driver for Denali(Cadence) NAND Flash Memory Controller IP.
>
> This driver requires two CONFIG macros:
>  - CONFIG_SPL_NAND_DENALI
>      Define to enable this driver.
>  - CONFIG_SYS_NAND_BAD_BLOCK_POS
>      Specify bad block mark position in the oob space. Typically 0.
>
> Signed-off-by: Masahiro Yamada <yamada.m at jp.panasonic.com>
> Cc: Chin Liang See <clsee at altera.com>
> Cc: Scott Wood <scottwood at freescale.com>
> ---
>
> Changes in v6: None
> Changes in v5:
>   - Remove the workaround added by v4
>     because the denali.h was merget into the mainline
>   - Add Kconfig entry
>   - Add comments where we read out some register values
>
> Changes in v4:
>   - Add a workaround to not depend on the Denali driver
>     posted by Chin Liang See.
>     This driver has been taking too long:
>     http://patchwork.ozlabs.org/patch/381305/
>
> Changes in v3: None
> Changes in v2:
>   - Avoid unaligned access
>   - Replace a magic number 0x2000 with PIPELINE_ACCESS
>


Applied to u-boot-uniphier/master.

-- 
Best Regards
Masahiro Yamada