[U-Boot] [PATCH 6/7] spi: altera: Add short note about EPCS/EPCQx1

[Jagan Teki]

On 20 October 2014 00:13, Marek Vasut <marex at denx.de> wrote:
> Add short documentation-alike note on how to use the Altera SPI
> driver with the EPCS/EPCQx1 FPGA IP block on SoCFPGA Cyclone V.
>
> Signed-off-by: Marek Vasut <marex at denx.de>
> Cc: Chin Liang See <clsee at altera.com>
> Cc: Dinh Nguyen <dinguyen at altera.com>
> Cc: Albert Aribaud <albert.u.boot at aribaud.net>
> Cc: Tom Rini <trini at ti.com>
> Cc: Wolfgang Denk <wd at denx.de>
> Cc: Pavel Machek <pavel at denx.de>
> Cc: Jagannadha Sutradharudu Teki <jagannadh.teki at gmail.com>
> ---
>  drivers/spi/altera_spi.c | 8 ++++++++
>  1 file changed, 8 insertions(+)
>
> diff --git a/drivers/spi/altera_spi.c b/drivers/spi/altera_spi.c
> index 3065e96..0566e4f 100644
> --- a/drivers/spi/altera_spi.c
> +++ b/drivers/spi/altera_spi.c
> @@ -4,6 +4,14 @@
>   * based on bfin_spi.c
>   * Copyright (c) 2005-2008 Analog Devices Inc.
>   * Copyright (C) 2010 Thomas Chou <thomas at wytron.com.tw>
> + * Copyright (C) 2014 Marek Vasut <marex at denx.de>

Looks not good to me - with few changes.

> + *
> + * SoCFPGA EPCS/EPCQx1 mini howto:
> + * - Instantiate EPCS/EPCQx1 Serial flash controller in QSys and rebuild
> + * - The controller base address is the "Base" in QSys + 0x400
> + * - Set MSEL[4:0]=10010 (AS Standard)
> + * - Load the bitstream into FPGA, enable bridges
> + * - Only then will the driver work

Instead of here,
Pls- try to test any hardware with this written sequence with the
obtained logs copy
that info on doc/SPI we're maintaining the test in this format.

Testing the written sequence with logs are more authentic than listing
on a driver file.

>   *
>   * SPDX-License-Identifier:    GPL-2.0+
>   */
> --
> 2.1.1
>

thanks!
-- 
Jagan.