[U-Boot] [PATCH v3 2/3] net: macb: enable GMAC IP without GE feature support

[Bo Shen]

The User Register in GMAC IP is used to select interface type.
When with GE feature, it is used to select interface between
RGMII and GMII. If without GE feature, it is used to select
interface between MII and RMII.

Signed-off-by: Bo Shen <voice.shen at atmel.com>
---
Changes in v3: None
Changes in v2: None

 drivers/net/macb.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/net/macb.c b/drivers/net/macb.c
index 375c8a4..6d48252 100644
--- a/drivers/net/macb.c
+++ b/drivers/net/macb.c
@@ -565,7 +565,13 @@ static int macb_init(struct eth_device *netdev, bd_t *bd)
 	macb_writel(macb, TBQP, macb->tx_ring_dma);
 
 	if (macb_is_gem(macb)) {
-#ifdef CONFIG_RGMII
+		/*
+		 * When the GMAC IP with GE feature, this bit is used to
+		 * select interface between RGMII and GMII.
+		 * When the GMAC IP without GE feature, this bit is used
+		 * to select interface between RMII and MII.
+		 */
+#if defined(CONFIG_RGMII) || defined(CONFIG_RMII)
 		gem_writel(macb, UR, GEM_BIT(RGMII));
 #else
 		gem_writel(macb, UR, 0);
-- 
2.1.0.24.g4109c28