[U-Boot] [PATCH] arm: socfpga: Add example config entry for EPCS/EPCQ SPI

[Marek Vasut]

On Thursday, October 30, 2014 at 03:38:40 PM, Jagan Teki wrote:
> On 30 October 2014 15:00, Marek Vasut <marex at denx.de> wrote:
> > Add example config file entry for the Altera SPI controller. This SPI
> > controller can also, under special conditions, be used to operate the
> > EPCS/EPCQ SPI NOR.
> > 
> > Signed-off-by: Marek Vasut <marex at denx.de>
> > Cc: Chin Liang See <clsee at altera.com>
> > Cc: Dinh Nguyen <dinguyen at opensource.altera.com>
> > Cc: Vince Bridgers <vbridger at altera.com>
> > Cc: Pavel Machek <pavel at denx.de>
> > Cc: Stefan Roese <sr at denx.de>
> > ---
> > 
> >  include/configs/socfpga_common.h | 19 +++++++++++++++++++
> >  1 file changed, 19 insertions(+)
> > 
> > diff --git a/include/configs/socfpga_common.h
> > b/include/configs/socfpga_common.h index 83a1bcd..1df886b 100644
> > --- a/include/configs/socfpga_common.h
> > +++ b/include/configs/socfpga_common.h
> > @@ -79,6 +79,25 @@
> > 
> >  #define CONFIG_SYS_PL310_BASE          SOCFPGA_MPUL2_ADDRESS
> >  
> >  /*
> > 
> > + * EPCS/EPCQx1 Serial Flash Controller
> > + */
> > +#ifdef CONFIG_ALTERA_SPI
> > +#define CONFIG_CMD_SPI
> > +#define CONFIG_CMD_SF
> > +#define CONFIG_SF_DEFAULT_SPEED                30000000
> > +#define CONFIG_SPI_FLASH
> > +#define CONFIG_SPI_FLASH_STMICRO
> > +#define CONFIG_SPI_FLASH_BAR
> > +/*
> > + * The base address is configurable in QSys, each board must specify the
> > + * base address based on it's particular FPGA configuration. Please note
> > + * that the address here is incremented by  0x400  from the Base address
> > + * selected in QSys, since the SPI registers are at offset +0x400.
> > + * #define CONFIG_SYS_SPI_BASE         0xff240400
> 
> So each board-specific config header will define CONFIG_SYS_SPI_BASE is it?
> for using ALTERA_SPI

Yes, the address is not fixed, since this is FPGA IP.

Best regards,
Marek Vasut