[U-Boot] [PATCH v3 2/7] Exynos5800: Add DTS for new board Peach-Pi
Akshay Saraswat
akshay.s at samsung.com
Fri Oct 31 09:55:49 CET 2014
We have a new board Peach-Pi similar to Peach-Pit. Peach-Pi
differs from Peach-Pit in configuration factors like display
resolution, memory size, SoC version etc.
Signed-off-by: Alim Akhtar <alim.akhtar at samsung.com>
Signed-off-by: Akshay Saraswat <akshay.s at samsung.com>
---
Changes since v2:
- Rebased this patch
Changes since v1:
- Rebased this patch
arch/arm/dts/Makefile | 3 +-
arch/arm/dts/exynos5800-peach-pi.dts | 157 +++++++++++++++++++++++++++++++++++
2 files changed, 159 insertions(+), 1 deletion(-)
create mode 100644 arch/arm/dts/exynos5800-peach-pi.dts
diff --git a/arch/arm/dts/Makefile b/arch/arm/dts/Makefile
index c346063..2b9bd93 100644
--- a/arch/arm/dts/Makefile
+++ b/arch/arm/dts/Makefile
@@ -11,7 +11,8 @@ dtb-$(CONFIG_EXYNOS5) += exynos5250-arndale.dtb \
exynos5250-snow.dtb \
exynos5250-smdk5250.dtb \
exynos5420-smdk5420.dtb \
- exynos5420-peach-pit.dtb
+ exynos5420-peach-pit.dtb \
+ exynos5800-peach-pi.dtb
dtb-$(CONFIG_TEGRA) += tegra20-harmony.dtb \
tegra20-medcom-wide.dtb \
tegra20-paz00.dtb \
diff --git a/arch/arm/dts/exynos5800-peach-pi.dts b/arch/arm/dts/exynos5800-peach-pi.dts
new file mode 100644
index 0000000..8aedf8e
--- /dev/null
+++ b/arch/arm/dts/exynos5800-peach-pi.dts
@@ -0,0 +1,157 @@
+/*
+ * SAMSUNG/GOOGLE Peach-Pit board device tree source
+ *
+ * Copyright (c) 2013 Samsung Electronics Co., Ltd.
+ * http://www.samsung.com
+ *
+ * SPDX-License-Identifier: GPL-2.0+
+ */
+
+/dts-v1/;
+#include "exynos54xx.dtsi"
+
+/ {
+ model = "Samsung/Google Peach Pi board based on Exynos5800";
+
+ compatible = "google,pit-rev#", "google,pit",
+ "google,peach", "samsung,exynos5800", "samsung,exynos5";
+
+ config {
+ google,bad-wake-gpios = <&gpio 0x56 0>; /* gpx0-6 */
+ hwid = "PIT TEST A-A 7848";
+ lazy-init = <1>;
+ };
+
+ aliases {
+ serial0 = "/serial at 12C30000";
+ console = "/serial at 12C30000";
+ pmic = "/i2c at 12ca0000";
+ };
+
+ dmc {
+ mem-manuf = "samsung";
+ mem-type = "ddr3";
+ clock-frequency = <800000000>;
+ arm-frequency = <1700000000>;
+ };
+
+ tmu at 10060000 {
+ samsung,min-temp = <25>;
+ samsung,max-temp = <125>;
+ samsung,start-warning = <95>;
+ samsung,start-tripping = <105>;
+ samsung,hw-tripping = <110>;
+ samsung,efuse-min-value = <40>;
+ samsung,efuse-value = <55>;
+ samsung,efuse-max-value = <100>;
+ samsung,slope = <274761730>;
+ samsung,dc-value = <25>;
+ };
+
+ /* MAX77802 is on i2c bus 4 */
+ i2c at 12ca0000 {
+ clock-frequency = <400000>;
+ power-regulator at 9 {
+ compatible = "maxim,max77802-pmic";
+ reg = <0x9>;
+ };
+ };
+
+ i2c at 12cd0000 { /* i2c7 */
+ clock-frequency = <100000>;
+ soundcodec at 20 {
+ reg = <0x20>;
+ compatible = "maxim,max98090-codec";
+ };
+
+ edp-lvds-bridge at 48 {
+ compatible = "parade,ps8625";
+ reg = <0x48>;
+ };
+ };
+
+ sound at 3830000 {
+ samsung,codec-type = "max98090";
+ };
+
+ i2c at 12e10000 { /* i2c9 */
+ clock-frequency = <400000>;
+ tpm at 20 {
+ compatible = "infineon,slb9645-tpm";
+ reg = <0x20>;
+ };
+ };
+
+ spi at 12d30000 { /* spi1 */
+ spi-max-frequency = <50000000>;
+ firmware_storage_spi: flash at 0 {
+ reg = <0>;
+
+ /*
+ * A region for the kernel to store a panic event
+ * which the firmware will add to the log.
+ */
+ elog-panic-event-offset = <0x01e00000 0x100000>;
+
+ elog-shrink-size = <0x400>;
+ elog-full-threshold = <0xc00>;
+ };
+ };
+
+ spi at 12d40000 { /* spi2 */
+ spi-max-frequency = <4000000>;
+ spi-deactivate-delay = <200>;
+ cros-ec at 0 {
+ reg = <0>;
+ compatible = "google,cros-ec";
+ spi-half-duplex;
+ spi-max-timeout-ms = <1100>;
+ spi-frame-header = <0xec>;
+ ec-interrupt = <&gpio 93 1>; /* GPX1_5 */
+
+ /*
+ * This describes the flash memory within the EC. Note
+ * that the STM32L flash erases to 0, not 0xff.
+ */
+ #address-cells = <1>;
+ #size-cells = <1>;
+ flash at 8000000 {
+ reg = <0x08000000 0x20000>;
+ erase-value = <0>;
+ };
+ };
+ };
+
+ xhci at 12000000 {
+ samsung,vbus-gpio = <&gpio 0x40 0>; /* H00 */
+ };
+
+ xhci at 12400000 {
+ samsung,vbus-gpio = <&gpio 0x41 0>; /* H01 */
+ };
+
+ fimd at 14400000 {
+ samsung,vl-freq = <60>;
+ samsung,vl-col = <1920>;
+ samsung,vl-row = <1080>;
+ samsung,vl-width = <1920>;
+ samsung,vl-height = <1080>;
+
+ samsung,vl-clkp;
+ samsung,vl-dp;
+ samsung,vl-bpix = <4>;
+
+ samsung,vl-hspw = <80>;
+ samsung,vl-hbpd = <172>;
+ samsung,vl-hfpd = <60>;
+ samsung,vl-vspw = <10>;
+ samsung,vl-vbpd = <25>;
+ samsung,vl-vfpd = <10>;
+ samsung,vl-cmd-allow-len = <0xf>;
+
+ samsung,winid = <3>;
+ samsung,interface-mode = <1>;
+ samsung,dp-enabled = <1>;
+ samsung,dual-lcd-enabled = <0>;
+ };
+};
--
1.9.1
More information about the U-Boot
mailing list