[U-Boot] [PATCH 2/2] board/ls1021aqds_d4: Add DDR4 support
York Sun
yorksun at freescale.com
Thu Sep 11 22:32:07 CEST 2014
LS1021AQDS has a variant with DDR4 slot. This patch adds a new target for
this variant and enables DDR4 support. RAW timing parameters are not added
for DDR4. The board timing parameters are only tuned for single-rank 1600
and 1800MT/s with Micron DIMM 9ASF51272AZ-2G1A1 due to availability.
Signed-off-by: York Sun <yorksun at freescale.com>
---
arch/arm/Kconfig | 3 +++
arch/arm/include/asm/arch-ls102xa/config.h | 5 +++++
board/freescale/ls1021aqds/Kconfig | 2 +-
board/freescale/ls1021aqds/ddr.c | 9 ++++++++-
board/freescale/ls1021aqds/ddr.h | 10 ++++++++++
...s_nor_defconfig => ls1021aqds_d4_nor_defconfig} | 1 +
include/configs/ls1021aqds.h | 4 +++-
7 files changed, 31 insertions(+), 3 deletions(-)
copy configs/{ls1021aqds_nor_defconfig => ls1021aqds_d4_nor_defconfig} (50%)
diff --git a/arch/arm/Kconfig b/arch/arm/Kconfig
index 11143a8..49c4b5a 100644
--- a/arch/arm/Kconfig
+++ b/arch/arm/Kconfig
@@ -473,6 +473,9 @@ config TARGET_LS2085A_SIMU
config TARGET_LS1021AQDS
bool "Support ls1021aqds_nor"
+config TARGET_LS1021AQDS_D4
+ bool "Support ls1021aqds_nor with DDR4"
+
config TARGET_LS1021ATWR
bool "Support ls1021atwr_nor"
diff --git a/arch/arm/include/asm/arch-ls102xa/config.h b/arch/arm/include/asm/arch-ls102xa/config.h
index ed78c33..a500b5b 100644
--- a/arch/arm/include/asm/arch-ls102xa/config.h
+++ b/arch/arm/include/asm/arch-ls102xa/config.h
@@ -50,7 +50,11 @@
#ifdef CONFIG_DDR_SPD
#define CONFIG_SYS_FSL_DDR_BE
#define CONFIG_VERY_BIG_RAM
+#ifdef CONFIG_SYS_FSL_DDR4
+#define CONFIG_SYS_FSL_DDRC_GEN4
+#else
#define CONFIG_SYS_FSL_DDRC_ARM_GEN3
+#endif
#define CONFIG_SYS_FSL_DDR
#define CONFIG_SYS_LS1_DDR_BLOCK1_SIZE ((phys_size_t)2 << 30)
#define CONFIG_MAX_MEM_MAPPED CONFIG_SYS_LS1_DDR_BLOCK1_SIZE
@@ -71,6 +75,7 @@
#define CONFIG_MAX_CPUS 2
#define CONFIG_SYS_FSL_IFC_BANK_COUNT 8
#define CONFIG_NUM_DDR_CONTROLLERS 1
+#define CONFIG_SYS_FSL_DDR_VER FSL_DDR_VER_5_0
#else
#error SoC not defined
#endif
diff --git a/board/freescale/ls1021aqds/Kconfig b/board/freescale/ls1021aqds/Kconfig
index c28bd2b..1f60d95 100644
--- a/board/freescale/ls1021aqds/Kconfig
+++ b/board/freescale/ls1021aqds/Kconfig
@@ -1,4 +1,4 @@
-if TARGET_LS1021AQDS
+if TARGET_LS1021AQDS || TARGET_LS1021AQDS_D4
config SYS_CPU
string
diff --git a/board/freescale/ls1021aqds/ddr.c b/board/freescale/ls1021aqds/ddr.c
index 679c654..5898e33 100644
--- a/board/freescale/ls1021aqds/ddr.c
+++ b/board/freescale/ls1021aqds/ddr.c
@@ -79,7 +79,6 @@ found:
*/
popts->wrlvl_override = 1;
popts->wrlvl_sample = 0xf;
- popts->cswl_override = DDR_CSWL_CS0;
/*
* Rtt and Rtt_WR override
@@ -89,9 +88,17 @@ found:
/* Enable ZQ calibration */
popts->zq_en = 1;
+#ifdef CONFIG_SYS_FSL_DDR4
+ popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR1_ODT(DDR_CDR_ODT_80ohm);
+ popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_80ohm) |
+ DDR_CDR2_VREF_OVRD(70); /* Vref = 70% */
+#else
+ popts->cswl_override = DDR_CSWL_CS0;
+
/* DHC_EN =1, ODT = 75 Ohm */
popts->ddr_cdr1 = DDR_CDR1_DHC_EN | DDR_CDR1_ODT(DDR_CDR_ODT_75ohm);
popts->ddr_cdr2 = DDR_CDR2_ODT(DDR_CDR_ODT_75ohm);
+#endif
}
#ifdef CONFIG_SYS_DDR_RAW_TIMING
diff --git a/board/freescale/ls1021aqds/ddr.h b/board/freescale/ls1021aqds/ddr.h
index 16d87cb..f819c99 100644
--- a/board/freescale/ls1021aqds/ddr.h
+++ b/board/freescale/ls1021aqds/ddr.h
@@ -30,6 +30,13 @@ static const struct board_specific_parameters udimm0[] = {
* num| hi| rank| clk| wrlvl | wrlvl | wrlvl | cpo |wrdata|2T
* ranks| mhz| GB |adjst| start | ctl2 | ctl3 | |delay |
*/
+#ifdef CONFIG_SYS_FSL_DDR4
+ {2, 1666, 0, 4, 7, 0x0808090B, 0x0C0D0E0A,},
+ {2, 1900, 0, 4, 6, 0x08080A0C, 0x0D0E0F0A,},
+ {1, 1666, 0, 4, 8, 0x090A0B0B, 0x0C0D0E0C,},
+ {1, 1900, 0, 4, 9, 0x0A0B0C0B, 0x0D0E0F0D,},
+ {1, 2200, 0, 4, 10, 0x0B0C0D0C, 0x0E0F110E,},
+#elif defined(CONFIG_SYS_FSL_DDR3)
{1, 833, 1, 6, 8, 0x06060607, 0x08080807, 0x1f, 2, 0},
{1, 1350, 1, 6, 8, 0x0708080A, 0x0A0B0C09, 0x1f, 2, 0},
{1, 833, 2, 6, 8, 0x06060607, 0x08080807, 0x1f, 2, 0},
@@ -39,6 +46,9 @@ static const struct board_specific_parameters udimm0[] = {
{2, 1350, 0, 6, 8, 0x0708080A, 0x0A0B0C09, 0x1f, 2, 0},
{2, 1666, 4, 4, 0xa, 0x0B08090C, 0x0B0E0D0A, 0x1f, 2, 0},
{2, 1666, 0, 4, 0xa, 0x0B08090C, 0x0B0E0D0A, 0x1f, 2, 0},
+#else
+#error DDR type not defined
+#endif
{}
};
diff --git a/configs/ls1021aqds_nor_defconfig b/configs/ls1021aqds_d4_nor_defconfig
similarity index 50%
copy from configs/ls1021aqds_nor_defconfig
copy to configs/ls1021aqds_d4_nor_defconfig
index 9e42d61..3c57481 100644
--- a/configs/ls1021aqds_nor_defconfig
+++ b/configs/ls1021aqds_d4_nor_defconfig
@@ -1,2 +1,3 @@
+CONFIG_SYS_EXTRA_OPTIONS="SYS_FSL_DDR4"
CONFIG_ARM=y
CONFIG_TARGET_LS1021AQDS=y
diff --git a/include/configs/ls1021aqds.h b/include/configs/ls1021aqds.h
index 657e3b6..bb47813 100644
--- a/include/configs/ls1021aqds.h
+++ b/include/configs/ls1021aqds.h
@@ -49,10 +49,12 @@ unsigned long get_board_ddr_clk(void);
#define CONFIG_DDR_SPD
#define SPD_EEPROM_ADDRESS 0x51
#define CONFIG_SYS_SPD_BUS_NUM 0
-#define CONFIG_SYS_DDR_RAW_TIMING
#define CONFIG_FSL_DDR_INTERACTIVE /* Interactive debugging */
+#ifndef CONFIG_SYS_FSL_DDR4
#define CONFIG_SYS_FSL_DDR3 /* Use DDR3 memory */
+#define CONFIG_SYS_DDR_RAW_TIMING
+#endif
#define CONFIG_DIMM_SLOTS_PER_CTLR 1
#define CONFIG_CHIP_SELECTS_PER_CTRL 4
--
1.7.9.5
More information about the U-Boot
mailing list