[U-Boot] [PATCH v2 08/11] dm: imx: Use gpio_request() to request GPIOs
Igor Grinberg
grinberg at compulab.co.il
Wed Sep 17 16:31:29 CEST 2014
On 09/17/14 17:00, Simon Glass wrote:
> Hi Igor,
>
> On 17 September 2014 06:13, Igor Grinberg <grinberg at compulab.co.il <mailto:grinberg at compulab.co.il>> wrote:
>
> Hi Simon,
>
> On 09/17/14 06:51, Simon Glass wrote:
> > GPIOs should be requested before use. Without this, driver model will not
> > permit the GPIO to be used.
> >
> > Signed-off-by: Simon Glass <sjg at chromium.org <mailto:sjg at chromium.org>>
> > ---
> >
> > Changes in v2:
> > - Check return values of gpio_request()
> >
> > arch/arm/imx-common/i2c-mxv7.c | 24 ++++++++++++++++++++++++
> > board/compulab/cm_fx6/cm_fx6.c | 15 +++++++++++++++
> > board/compulab/cm_fx6/common.c | 7 +++++++
> > 3 files changed, 46 insertions(+)
> >
[...]
> > diff --git a/board/compulab/cm_fx6/common.c b/board/compulab/cm_fx6/common.c
> > index 1f39679..e4d7e2e 100644
> > --- a/board/compulab/cm_fx6/common.c
> > +++ b/board/compulab/cm_fx6/common.c
> > @@ -79,6 +79,13 @@ void cm_fx6_set_ecspi_iomux(void)
> >
> > int board_spi_cs_gpio(unsigned bus, unsigned cs)
> > {
> > +#ifndef CONFIG_SPL_BUILD
> > + int ret;
> > +
> > + ret = gpio_request(CM_FX6_ECSPI_BUS0_CS0, "ecspi_bus0_cs0");
> > + if (ret)
> > + return ret;
> > +#endif
>
> Is there a reason for excluding this request from spl builds?
> We do build with CONFIG_SPL_GPIO_SUPPORT and we don't have a
> problem with spl size.
> So, if there is no strong reason to exclude it from spl build,
> I'd like to remove the #ifndef.
>
>
> It isn't supported by DM yet.
AFAICS, gpio_request() is available for SPL.
So in such case the non-DM version will be used and
I can't see any problem with this (unless it does not work for some reason).
>
>
>
> > return (bus == 0 && cs == 0) ? (CM_FX6_ECSPI_BUS0_CS0) : -1;
> > }
> > #endif
> >
>
> --
> Regards,
> Igor.
>
>
> Regards,
> Simon
>
--
Regards,
Igor.
More information about the U-Boot
mailing list