[U-Boot] [PATCH v2 0/80] dm: Add USB support

[Simon Glass]

Hi Marek,

On 26 March 2015 at 13:40, Marek Vasut <marex at denx.de> wrote:
> On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote:
>> This series adds driver model support to USB. The intent is to permit the
>> various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any number of
>> USB ports of different types.
>>
>> With the RFC series, only USB controllers had a real driver model device.
>> USB devices (including the hub in the controller) were not modelled as
>> driver model devices.
>>
>> While this was expedient, and produced much fewer patches, it is not a
>> long-term solution. Also, since then, driver model Ethernet support (which
>> USB can use) has been merged to u-boot-dm/next. It seems better to bite the
>> bullet and do a full conversion.
>
> Whew.
>
> Reviewed-by: Marek Vasut <marex at denx.de>

Thanks very much for working through these!

Unless there are other comments I plan to apply this to u-boot-dm/next
in the next few days. I expect it will need some tweaking as boards
are moved over too.

Regards,
Simon