[U-Boot] [PATCH v2 0/80] dm: Add USB support

[Marek Vasut]

On Monday, April 06, 2015 at 01:38:13 AM, Simon Glass wrote:
> Hi Marek,

Hi Simon,

> On 26 March 2015 at 13:40, Marek Vasut <marex at denx.de> wrote:
> > On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote:
> >> This series adds driver model support to USB. The intent is to permit
> >> the various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any
> >> number of USB ports of different types.
> >> 
> >> With the RFC series, only USB controllers had a real driver model
> >> device. USB devices (including the hub in the controller) were not
> >> modelled as driver model devices.
> >> 
> >> While this was expedient, and produced much fewer patches, it is not a
> >> long-term solution. Also, since then, driver model Ethernet support
> >> (which USB can use) has been merged to u-boot-dm/next. It seems better
> >> to bite the bullet and do a full conversion.
> > 
> > Whew.
> > 
> > Reviewed-by: Marek Vasut <marex at denx.de>
> 
> Thanks very much for working through these!
> 
> Unless there are other comments I plan to apply this to u-boot-dm/next
> in the next few days. I expect it will need some tweaking as boards
> are moved over too.

Please apply, I'm really looking forward to this.

Thank you very much for putting all the effort into this !

Best regards,
Marek Vasut