[U-Boot] [PATCH v2 0/80] dm: Add USB support

[Simon Glass]

Hi Marek,

On 6 April 2015 at 07:13, Marek Vasut <marex at denx.de> wrote:
> On Monday, April 06, 2015 at 01:38:13 AM, Simon Glass wrote:
>> Hi Marek,
>
> Hi Simon,
>
>> On 26 March 2015 at 13:40, Marek Vasut <marex at denx.de> wrote:
>> > On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote:
>> >> This series adds driver model support to USB. The intent is to permit
>> >> the various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any
>> >> number of USB ports of different types.
>> >>
>> >> With the RFC series, only USB controllers had a real driver model
>> >> device. USB devices (including the hub in the controller) were not
>> >> modelled as driver model devices.
>> >>
>> >> While this was expedient, and produced much fewer patches, it is not a
>> >> long-term solution. Also, since then, driver model Ethernet support
>> >> (which USB can use) has been merged to u-boot-dm/next. It seems better
>> >> to bite the bullet and do a full conversion.
>> >
>> > Whew.
>> >
>> > Reviewed-by: Marek Vasut <marex at denx.de>
>>
>> Thanks very much for working through these!
>>
>> Unless there are other comments I plan to apply this to u-boot-dm/next
>> in the next few days. I expect it will need some tweaking as boards
>> are moved over too.
>
> Please apply, I'm really looking forward to this.
>
> Thank you very much for putting all the effort into this !

OK, I'll apply to u-boot-dm/next, do a bit more testing, and apply. It
will be great to get this moved over.

Regards,
Simon