[U-Boot] [PATCH 04/12] arm: mx6: cm-fx6: setup hdmi only on hdmi enable
Stefano Babic
sbabic at denx.de
Sun Aug 2 10:53:47 CEST 2015
On 23/07/2015 16:19, Nikita Kiryanov wrote:
> Refactor display code to only setup hdmi if do_enable_hdmi() is invoked.
>
> Cc: Stefano Babic <sbabic at denx.de>
> Cc: Igor Grinberg <grinberg at compulab.co.il>
> Signed-off-by: Nikita Kiryanov <nikita at compulab.co.il>
> ---
> board/compulab/cm_fx6/cm_fx6.c | 9 +++------
> 1 file changed, 3 insertions(+), 6 deletions(-)
>
> diff --git a/board/compulab/cm_fx6/cm_fx6.c b/board/compulab/cm_fx6/cm_fx6.c
> index 3e518c1..e85c8ab 100644
> --- a/board/compulab/cm_fx6/cm_fx6.c
> +++ b/board/compulab/cm_fx6/cm_fx6.c
> @@ -52,6 +52,9 @@ int splash_screen_prepare(void)
> #ifdef CONFIG_IMX_HDMI
> static void cm_fx6_enable_hdmi(struct display_info_t const *dev)
> {
> + struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
> + imx_setup_hdmi();
> + setbits_le32(&mxc_ccm->CCGR3, MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK);
> imx_enable_hdmi_phy();
> }
>
> @@ -79,15 +82,9 @@ static struct display_info_t preset_hdmi_1024X768 = {
>
> static void cm_fx6_setup_display(void)
> {
> - struct mxc_ccm_reg *mxc_ccm = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
> struct iomuxc *const iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
> - int reg;
>
> enable_ipu_clock();
> - imx_setup_hdmi();
> - reg = __raw_readl(&mxc_ccm->CCGR3);
> - reg |= MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK;
> - writel(reg, &mxc_ccm->CCGR3);
> clrbits_le32(&iomuxc_regs->gpr[3], MXC_CCM_CCGR3_IPU1_IPU_DI0_MASK);
> }
>
>
Applied to u-boot-imx, thanks !
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================
More information about the U-Boot
mailing list