[U-Boot] [PATCH v3 15/15] imx: mx6ul_14x14_evk add basic board support

[Fabio Estevam]

Hi Peng,

On Mon, Jul 20, 2015 at 8:28 AM, Peng Fan <Peng.Fan at freescale.com> wrote:
> 1. Add USDHC, I2C, UART, 74LV, USB, QSPI support.
> 2. Support SPL
> 3. CONFIG_MX6UL_14X14_EVK_EMMC_REWORK is introduced, this board default
>    supports sd for usdhc2, but can do hardware rework to make usdhc2 support
>    emmc.
>
> Boot Log:
> U-Boot SPL 2015.07-rc3-00124-g35d727b (Jul 20 2015 - 18:40:59)
> reading u-boot.img
> reading u-boot.img
>
> U-Boot 2015.07-rc3-00124-g35d727b (Jul 20 2015 - 18:40:59 +0800)
>
> CPU:   Freescale i.MX6UL rev1.0 792 MHz (running at 396 MHz)
> CPU:   Commercial temperature grade (0C to 95C)CPU:   Thermal invalid data, fuse: 0x0
>  - invalid sensor device
>  Reset cause: POR
>  Board: MX6UL 14x14 EVK
>  I2C:   ready
>  DRAM:  512 MiB
>  MMC:   FSL_SDHC: 0, FSL_SDHC: 1
>  *** Warning - bad CRC, using default environment
>
>  In:    serial
>  Out:   serial
>  Err:   serial
>  Net:   CPU Net Initialization Failed
>  No ethernet found.
>  Hit any key to stop autoboot:  0
>
> Signed-off-by: Peng Fan <Peng.Fan at freescale.com>

I am running u-boot-imx tree that has this patch applied, but I am not
able to boot from SD card:

U-Boot SPL 2015.07-22910-g1c23c1e (Aug 10 2015 - 16:17:50)
MMC: no card present
spl: mmc init failed with error: -16
### ERROR ### Please RESET the board ###

Any ideas?

Regards,

Fabio Estevam