[U-Boot] [PATCH V2] ti: qspi: set flash quad bit based on quad support flag

Vishal Mahaveer vishalm at ti.com
Mon Aug 17 17:47:51 CEST 2015


Update op_mode_rx flag based on CONFIG_QSPI_QUAD_SUPPORT flag,
instead of platform.

Signed-off-by: Vishal Mahaveer <vishalm at ti.com>
Reviewed-by: Jagan Teki <jteki at openedev.com>
---
 Re-sending, because missed copying Tom Rini
 http://marc.info/?l=u-boot&m=143948953129327&w=2

 drivers/spi/ti_qspi.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index 3356c0f..af40ec8 100644
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -106,7 +106,6 @@ static void ti_spi_setup_spi_register(struct ti_qspi_slave *qslave)
 	slave->memory_map = (void *)MMAP_START_ADDR_DRA;
 #else
 	slave->memory_map = (void *)MMAP_START_ADDR_AM43x;
-	slave->op_mode_rx = 8;
 #endif
 
 #ifdef CONFIG_QSPI_QUAD_SUPPORT
@@ -114,6 +113,7 @@ static void ti_spi_setup_spi_register(struct ti_qspi_slave *qslave)
 			QSPI_SETUP0_NUM_D_BYTES_8_BITS |
 			QSPI_SETUP0_READ_QUAD | QSPI_CMD_WRITE |
 			QSPI_NUM_DUMMY_BITS);
+	slave->op_mode_rx = SPI_OPM_RX_QOF;
 #else
 	memval |= QSPI_CMD_READ | QSPI_SETUP0_NUM_A_BYTES |
 			QSPI_SETUP0_NUM_D_BYTES_NO_BITS |
-- 
1.7.4.1



More information about the U-Boot mailing list