[U-Boot] [PATCHv4 5/9] arm: socfpga: arria10: add socfpga_arria10_socdk config

[dinguyen at opensource.altera.com]

From: Dinh Nguyen <dinguyen at opensource.altera.com>

Add config for the Arria10 SoC Development Kit.

Signed-off-by: Dinh Nguyen <dinguyen at opensource.altera.com>
Acked-by: Marek Vasut <marex at denx.de>
---
v4: none
v3: further clean up, remove extra defines, keep bare mininum options
v2: clean up socfpga_arria10_socdk.h to use socfpga_common.h
---
 include/configs/socfpga_arria10_socdk.h | 94 +++++++++++++++++++++++++++++++++
 1 file changed, 94 insertions(+)
 create mode 100644 include/configs/socfpga_arria10_socdk.h

diff --git a/include/configs/socfpga_arria10_socdk.h b/include/configs/socfpga_arria10_socdk.h
new file mode 100644
index 0000000..577f60f
--- /dev/null
+++ b/include/configs/socfpga_arria10_socdk.h
@@ -0,0 +1,94 @@
+/*
+ *  Copyright (C) 2015 Altera Corporation <www.altera.com>
+ *
+ * SPDX-License-Identifier:	GPL-2.0
+ */
+
+#ifndef __CONFIG_SOCFGPA_ARRIA10_H__
+#define __CONFIG_SOCFGPA_ARRIA10_H__
+
+#include <asm/arch/base_addr_a10.h>
+/* U-Boot Commands */
+#define CONFIG_SYS_NO_FLASH
+#define CONFIG_DOS_PARTITION
+#define CONFIG_FAT_WRITE
+#define CONFIG_HW_WATCHDOG
+
+#define CONFIG_CMD_ASKENV
+#define CONFIG_CMD_BOOTZ
+#define CONFIG_CMD_CACHE
+#define CONFIG_CMD_DHCP
+#define CONFIG_CMD_EXT4
+#define CONFIG_CMD_EXT4_WRITE
+#define CONFIG_CMD_FAT
+#define CONFIG_CMD_FS_GENERIC
+#define CONFIG_CMD_GREPENV
+#define CONFIG_CMD_MMC
+#define CONFIG_CMD_PING
+
+/*
+ * Memory configurations
+ */
+#define PHYS_SDRAM_1_SIZE		0x2000000
+
+/* Booting Linux */
+#define CONFIG_BOOTDELAY	3
+#define CONFIG_BOOTFILE		"zImage"
+#define CONFIG_BOOTARGS		"console=ttyS0," __stringify(CONFIG_BAUDRATE)
+#define CONFIG_BOOTCOMMAND      "run mmcload; run mmcboot"
+#define CONFIG_LOADADDR		0x01000000
+#define CONFIG_SYS_LOAD_ADDR	CONFIG_LOADADDR
+
+/*
+ * Display CPU and Board Info
+ */
+#define CONFIG_DISPLAY_CPUINFO
+#define CONFIG_DISPLAY_BOARDINFO
+#define CONFIG_DISPLAY_BOARDINFO_LATE
+
+/* Ethernet on SoC (EMAC) */
+#if defined(CONFIG_CMD_NET)
+
+/* PHY */
+#define CONFIG_PHY_MICREL
+#define CONFIG_PHY_MICREL_KSZ9031
+
+#endif
+
+#define CONFIG_ENV_IS_IN_MMC
+#define CONFIG_SYS_MMC_ENV_DEV		0/* device 0 */
+#define CONFIG_ENV_OFFSET		512/* just after the MBR */
+
+/*
+ * arguments passed to the bootz command. The value of
+ * CONFIG_BOOTARGS goes into the environment value "bootargs".
+ * Do note the value will overide also the chosen node in FDT blob.
+ */
+#define CONFIG_BOOTARGS "console=ttyS0," __stringify(CONFIG_BAUDRATE)
+
+#define CONFIG_EXTRA_ENV_SETTINGS \
+	"verify=n\0" \
+	"loadaddr= " __stringify(CONFIG_SYS_LOAD_ADDR) "\0" \
+	"ramboot=setenv bootargs " CONFIG_BOOTARGS ";" \
+		"bootm ${loadaddr} - ${fdt_addr}\0" \
+	"bootimage=zImage\0" \
+	"fdt_addr=100\0" \
+	"fdtimage=socfpga.dtb\0" \
+		"fsloadcmd=ext2load\0" \
+	"bootm ${loadaddr} - ${fdt_addr}\0" \
+	"mmcroot=/dev/mmcblk0p2\0" \
+	"mmcboot=setenv bootargs " CONFIG_BOOTARGS \
+		" root=${mmcroot} rw rootwait;" \
+		"bootz ${loadaddr} - ${fdt_addr}\0" \
+	"mmcload=mmc rescan;" \
+		"load mmc 0:1 ${loadaddr} ${bootimage};" \
+		"load mmc 0:1 ${fdt_addr} ${fdtimage}\0" \
+	"qspiroot=/dev/mtdblock0\0" \
+	"qspirootfstype=jffs2\0" \
+	"qspiboot=setenv bootargs " CONFIG_BOOTARGS \
+		" root=${qspiroot} rw rootfstype=${qspirootfstype};"\
+		"bootm ${loadaddr} - ${fdt_addr}\0"
+
+/* The rest of the configuration is shared */
+#include <configs/socfpga_common.h>
+#endif	/* __CONFIG_H */
-- 
2.6.2