[U-Boot] [PATCH v2 2/8] arm: relocation: clear .bss section with arch memset if defined

Przemyslaw Marczak p.marczak at samsung.com
Mon Feb 16 16:13:15 CET 2015


For ARM architecture, enable the CONFIG_USE_ARCH_MEMSET/MEMCPY,
will highly increase the memset/memcpy performance. This is able
thanks to the ARM multiple register instructions.

Unfortunatelly the relocation is done without the cache enabled,
so it takes some time, but zeroing the BSS memory takes much more
longer, especially for the configs with big static buffers.

A quick test confirms, that the boot time improvement after using
the arch memcpy for relocation has no significant meaning.
The same test confirms that enable the memset for zeroing BSS,
reduces the boot time.

So this patch enables the arch memset for zeroing the BSS after
the relocation process. For ARM boards, this can be enabled
in board configs by defining: 'CONFIG_USE_ARCH_MEMSET'.

This was tested on Trats2.
A quick test with trace. Boot time from start to main_loop() entry:
- ~1384ms - before this change
-  ~888ms - after this change

Signed-off-by: Przemyslaw Marczak <p.marczak at samsung.com>
Cc: Albert Aribaud <albert.u.boot at aribaud.net>
Cc: Tom Rini <trini at ti.com>
---
 arch/arm/lib/crt0.S | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/arch/arm/lib/crt0.S b/arch/arm/lib/crt0.S
index 22df3e5..fab3d2c 100644
--- a/arch/arm/lib/crt0.S
+++ b/arch/arm/lib/crt0.S
@@ -115,14 +115,22 @@ here:
 	bl	c_runtime_cpu_setup	/* we still call old routine here */
 
 	ldr	r0, =__bss_start	/* this is auto-relocated! */
-	ldr	r1, =__bss_end		/* this is auto-relocated! */
 
+#ifdef CONFIG_USE_ARCH_MEMSET
+	ldr	r3, =__bss_end		/* this is auto-relocated! */
+	mov	r1, #0x00000000		/* prepare zero to clear BSS */
+
+	subs	r2, r3, r0		/* r2 = memset len */
+	bl	memset
+#else
+	ldr	r1, =__bss_end		/* this is auto-relocated! */
 	mov	r2, #0x00000000		/* prepare zero to clear BSS */
 
 clbss_l:cmp	r0, r1			/* while not at end of BSS */
 	strlo	r2, [r0]		/* clear 32-bit BSS word */
 	addlo	r0, r0, #4		/* move to next */
 	blo	clbss_l
+#endif
 
 	bl coloured_LED_init
 	bl red_led_on
-- 
1.9.1



More information about the U-Boot mailing list