[U-Boot] [PATCH v2 06/12] virt-dt: Allow reservation of the secure region when it is in a RAM carveout.

Jan Kiszka jan.kiszka at siemens.com
Tue Feb 17 12:32:28 CET 2015


On 2015-02-17 11:46, Mark Rutland wrote:
> On Tue, Feb 17, 2015 at 08:09:57AM +0000, Jan Kiszka wrote:
>> On 2015-02-16 16:38, Jan Kiszka wrote:
>>> On 2015-02-16 15:56, Mark Rutland wrote:
>>>> On Mon, Feb 16, 2015 at 02:31:21PM +0000, Jan Kiszka wrote:
>>>>> On 2015-02-16 15:25, Mark Rutland wrote:
>>>>>> On Mon, Feb 16, 2015 at 01:51:37PM +0000, Jan Kiszka wrote:
>>>>>>> On 2015-02-16 14:42, Mark Rutland wrote:
>>>>>>>> On Mon, Feb 16, 2015 at 12:54:43PM +0000, Jan Kiszka wrote:
>>>>>>>>> From: Ian Campbell <ijc at hellion.org.uk>
>>>>>>>>>
>>>>>>>>> In this case the secure code lives in RAM, and hence needs to be reserved, but
>>>>>>>>> it has been relocated, so the reservation of __secure_start does not apply.
>>>>>>>>>
>>>>>>>>> Add support for setting CONFIG_ARMV7_SECURE_RESERVE_SIZE to reserve such a
>>>>>>>>> region.
>>>>>>>>>
>>>>>>>>> This will be used in a subsequent patch for Jetson-TK1
>>>>>>>>
>>>>>>>> Using a memreserve and allowing the OS to map the memory but not poke it
>>>>>>>> can be problematic due to the potential of mismatched attributes between
>>>>>>>> the monitor and the OS.
>>>>>>>
>>>>>>> OK, here my knowledge is not yet sufficient to process this remark. What
>>>>>>> kind of problems can arise from what kind of attribute mismatch? And why
>>>>>>> should the OS be able to cause problems for the monitor?
>>>>>>
>>>>>> For example, consider the case of the region being mapped cacheable by
>>>>>> the OS but not by the monitor. The monitor communicates between cores
>>>>>> expecting to never hit in a cache (because it uses a non-cacheable
>>>>>> mapping), but the mapping used by the OS can cause the region to be
>>>>>> allocated into caches at any point in time even if it never accesses the
>>>>>> region explicitly.
>>>>>>
>>>>>> The CPU _may_ hit in a cache even if making a non-cacheable access (this
>>>>>> is called an "unexepcted data cache hit"), so the cache allocations
>>>>>> caused by the OS can mask data other CPUs wrote straight to memory.
>>>>>>
>>>>>> Other than that case, I believe the rules given in the ARM ARM for
>>>>>> mismatched memory attributes may apply for similar reasons.  Thus
>>>>>> allowing the OS to map this memory can cause a loss of coherency on the
>>>>>> monitor side, if the OS and monitor map the region with different
>>>>>> attributes.
>>>>>>
>>>>>> This is all IMPLEMENTATION DEFINED, so it may be that you're fine on the
>>>>>> system you're dealing with. I don't immediately know whether that is the
>>>>>> case, however. Never telling the OS about the memory in the first place
>>>>>> avoids the possibility in all cases.
>>>>>
>>>>> But from a security point of view, it must not matter if the OS maps the
>>>>> memory or not - the monitor must be robust against that, no? If the
>>>>> architecture cannot provide such guarantees, it has to be worked around
>>>>> in software in the monitor (I hope you can do so...).
>>>>
>>>> Well, yes and no.
>>>>
>>>> In this case it sounds like due to the security controller you should
>>>> never encounter the mismatched attributes issue in the first place,
>>>> though you may encounter issues w.r.t. speculative accesses triggering
>>>> violations arbitrarily. Not telling the OS about the secure memory means
>>>> that said violations shouldn't occur in normal operation; only when the
>>>> non-secure OS is trying to do something bad.
>>>>
>>>> If the OS has access to the memory, then you're already trusting it to
>>>> not write to there or you can't trust that memory at all (and hence
>>>> cannot use it). Given that means you must already assume that the OS is
>>>> cooperative, it's simpler to not tell it about the memory than to add
>>>> cache maintenance around every memory access within the monitor. You can
>>>> never make things secure in this case, but you can at least offer the
>>>> abstraction provided by PSCI.
>>>>
>>>> So as far as I can see in either case it's better to not tell the OS
>>>> about the memory you wish to use from the monitor. If you have no HW
>>>> protection and can't trust the OS then you've already lost, and if you
>>>> do have HW protection you don't want it to trigger
>>>> continuously/spuriously as a result of speculation.
>>>
>>> OK, that makes sense again.
>>>
>>> Now I just need to figure out how to split/adjust the memory node
>>> instead of adding a reservation region.
>>
>> This is getting invasive:
>>
>> If I add carveouts via adjusting memory banks, I need to account for the
>> case that an existing bank is split into two halves, creating additional
>> banks this way. But then current fdt_fixup_memory_banks will no longer
>> work due to its limitation to the number of physical banks. I could
>> always add one spare bank to that service, ok, but then the next use
>> case for carveouts will hit the wall again. So I better double that
>> limit, or so.
> 
> Yeah, not fun.
> 
> If the code is position-independent then you might be able to simply
> carve out a sufficient proportion from the start of the first entry or
> the end of the last one, which would avoid splitting. If either of said
> regions are too small for the monitor code then it's questionable as to
> whether the OS can make use of it.

The code /seems/ to be position-independent, but locations are so far
hard-coded in those places that prepare it and move it around. Maybe we
can decide about the location at runtime, maybe we can simply demand it
to be at the end or the beginning of some bank.

> 
>> Also, are there any architectural or OS-implementation related
>> restrictions on the alignment of bank start addresses and sizes? Just to
>> make sure we don't stumble over some side effects of punching holes into
>> that device tree node.
> 
> I would guess that we need to at least pad the carevout to page-aligned
> to prevent any particular OS from mapping a page for the sake of a few
> bytes left unused by the monitor.
> 
> From a quick look at the Linux arm_add_memory and memblock code it looks
> like Linux won't map partial pages, but I don't know what Xen and others
> do, and given we know that we want to keep the relevant pages exclusive
> to the monitor anyway padding to age boundaries seems like a sensible
> thing to do.
> 
> My one concern would be early mappings; I believe that the initial page
> tables use (2MiB) section/block mappings to map the kernel and some
> initial memory (including the DTB) before the memory nodes are parsed,
> so the carevout would need to be placed away from where the kernel and
> DTB were loaded in order to prevent those early mappings from covering
> it. I'm unfortunately not sure on the full details there.

That makes be wonder again if we are trying to solve real issues: What
is the OS supposed to do with a memory reserve map, what does it have to
avoid doing with it? Is the semantic really so weak that we cannot use
it here?

Jan


More information about the U-Boot mailing list