[U-Boot] [PATCH 09/20] tegra: spi: Support slow SPI rates

Simon Glass sjg at chromium.org
Tue Feb 17 23:29:43 CET 2015


Use the oscillator as the source clock when we cannot achieve a low-enough
speed with the peripheral clock. This happens when we request 3MHz on a SPI
clock, for example.

Signed-off-by: Simon Glass <sjg at chromium.org>
---

 drivers/spi/tegra114_spi.c | 18 +++++++++++++++---
 1 file changed, 15 insertions(+), 3 deletions(-)

diff --git a/drivers/spi/tegra114_spi.c b/drivers/spi/tegra114_spi.c
index a73c6b0..1c5368b 100644
--- a/drivers/spi/tegra114_spi.c
+++ b/drivers/spi/tegra114_spi.c
@@ -143,6 +143,7 @@ static int tegra114_spi_probe(struct udevice *bus)
 {
 	struct tegra_spi_platdata *plat = dev_get_platdata(bus);
 	struct tegra114_spi_priv *priv = dev_get_priv(bus);
+	ulong rate;
 
 	priv->regs = (struct spi_regs *)plat->base;
 
@@ -150,9 +151,20 @@ static int tegra114_spi_probe(struct udevice *bus)
 	priv->freq = plat->frequency;
 	priv->periph_id = plat->periph_id;
 
-	/* Change SPI clock to correct frequency, PLLP_OUT0 source */
-	clock_start_periph_pll(priv->periph_id, CLOCK_ID_PERIPH,
-			       priv->freq);
+	/*
+	 * Change SPI clock to correct frequency, PLLP_OUT0 source, falling
+	 * back to the oscillator if that is too fast.
+	 */
+	rate = clock_start_periph_pll(priv->periph_id, CLOCK_ID_PERIPH,
+				      priv->freq);
+	if (rate > priv->freq + 100000) {
+		rate = clock_start_periph_pll(priv->periph_id, CLOCK_ID_OSC,
+					      priv->freq);
+		if (rate != priv->freq) {
+			printf("Warning: SPI '%s' requested clock %u, actual clock %lu\n",
+			       bus->name, priv->freq, rate);
+		}
+	}
 
 	setbits_le32(&priv->regs->command1, SPI_CMD1_M_S | SPI_CMD1_CS_SW_HW |
 		     (priv->mode << SPI_CMD1_MODE_SHIFT) | SPI_CMD1_CS_SW_VAL);
-- 
2.2.0.rc0.207.ga3a616c



More information about the U-Boot mailing list