[U-Boot] [GIT PULL] Zynq changes

[Michal Simek]

Hi Tom,

please pull these changes to your tree. The most of that changes are DT
related which is simple synchronization DTSes with the kernel where
binding was properly reviewed.

Thanks,
Michal

The following changes since commit 26473945ad6667183296e7edee2a65edf31bb6f7:

  Merge branch 'master' of http://git.denx.de/u-boot-sunxi (2015-07-25
09:04:18 -0400)

are available in the git repository at:

  git://www.denx.de/git/u-boot-microblaze.git zynq

for you to fetch changes up to 711e5e26b41457e658155e7c225c9ccfed0182ef:

  cmd_mp: Add support for showing all CPU status by one command
(2015-07-28 11:56:29 +0200)

----------------------------------------------------------------
Michal Simek (29):
      zynq: gem: Setting up WRAP bit for one TX bd
      zynqmp: mp: Simplify set_r5_start handling
      zynqmp: Add support for IP detection via SLCR
      ARM: zynq: DT: Use the right names for nodes
      ARM: zynq: DT: Add missing nodes to DTSI
      ARM: zynq: DT: Add a fixed regulator for CPU voltage
      ARM: zynq: DT: Migrate UART to Cadence binding
      ARM: zynq: DT: Remove 222 MHz OPP
      spi: Fix zynq SPI binding
      ARM: zynq: DT: Fix GEM register area size
      ARM: zynq: DT: Use the zynq binding with macb
      ARM: zynq: DT: Clean up timer device tree nodes
      ARM: zynq: DT: Cleanup address-cells and size-cells
      ARM: zynq: DT: Add pinctrl node
      ARM: zynq: DT: Add reference to bus node
      ARM: zynq: DT: Sync zc702/zc706/zed/zybo DT with kernel
      ARM: zynq: DT: Update years in copyright
      ARM: zynq: DT: Get rid of ps-clk-frequency
      ARM: zynq: DT: Add missing interrupt for L2 pl310
      ARM: zynq: DT: Add zc702 pushbuttons to DT as gpio-keys
      ARM: zynq: DT: Update zc770 dtses
      ARM: zynq: Add support for zc770-xm011
      ARM: zynqmp: Wire up ethernet controllers
      ARM: zynqmp: Wire up SATA for the board
      zynqmp: Show EL level where U-Boot runs
      net: gem: Extend timeout value
      zynq: Fix typo in Makefile about custom ps7_init file
      spi: zynq_spi: Simplify debug macro
      cmd_mp: Add support for showing all CPU status by one command

Siva Durga Prasad Paladugu (7):
      zynqmp: gem: Set data bus width to 64bit for arm64
      zynqmp: gem: Flush the rx buffers while transmitting
      zynq: gem: Increase the Rx buffer descriptors to 32
      zynqmp: Kconfig: Move zynqmp Kconfig
      zynqmp: Define ep config for ZynqMP
      Kconfig: zynqmp: Move CONFIG_SYS_TEXT_BASE to defconfig
      zynqmp: Provide option to enable uart dcc support for zynqmp

 Kconfig                                                         |   2 +-
 arch/arm/Kconfig                                                |   5 ++-
 arch/arm/cpu/armv8/Makefile                                     |   2 +-
 arch/arm/cpu/armv8/zynqmp/Kconfig                               |  23
++++++++++
 arch/arm/cpu/armv8/zynqmp/Makefile                              |   1 +
 arch/arm/cpu/armv8/zynqmp/mp.c                                  |   7 +--
 arch/arm/cpu/armv8/zynqmp/slcr.c                                |  63
+++++++++++++++++++++++++++
 arch/arm/dts/Makefile                                           |   1 +
 arch/arm/dts/zynq-7000.dtsi                                     | 174
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++------------
 arch/arm/dts/zynq-zc702.dts                                     | 372
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++--
 arch/arm/dts/zynq-zc706.dts                                     | 293
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++--
 arch/arm/dts/zynq-zc770-xm010.dts                               |  75
+++++++++++++++++++++++++++++---
 arch/arm/dts/zynq-zc770-xm011.dts                               |  65
++++++++++++++++++++++++++++
 arch/arm/dts/zynq-zc770-xm012.dts                               |  51
++++++++++++++++++++--
 arch/arm/dts/zynq-zc770-xm013.dts                               |  62
++++++++++++++++++++++++--
 arch/arm/dts/zynq-zed.dts                                       |  46
++++++++++++++++++--
 arch/arm/dts/zynq-zybo.dts                                      |  38
++++++++++++++--
 arch/arm/include/asm/arch-zynqmp/hardware.h                     |  16
+++++++
 arch/arm/include/asm/arch-zynqmp/sys_proto.h                    |   6 +++
 board/xilinx/zynq/Makefile                                      |   2 +-
 board/xilinx/zynqmp/Kconfig                                     |  15
-------
 board/xilinx/zynqmp/MAINTAINERS                                 |   5 ++-
 board/xilinx/zynqmp/zynqmp.c                                    |  37
++++++++++++++++
 common/cmd_mp.c                                                 |  22
++++++++++
 configs/{xilinx_zynqmp_defconfig => xilinx_zynqmp_ep_defconfig} |   5 ++-
 configs/zynq_zc770_xm011_defconfig                              |  13
++++++
 doc/device-tree-bindings/spi/spi-zynq.txt                       |  35
++++++++-------
 drivers/net/zynq_gem.c                                          |  26
++++++++---
 drivers/spi/zynq_spi.c                                          |   4 +-
 include/configs/xilinx_zynqmp.h                                 |  48
+++++++++++++++++----
 include/configs/xilinx_zynqmp_ep.h                              |  27
++++++++++++
 include/configs/zynq_zc770.h                                    |   3 ++
 32 files changed, 1427 insertions(+), 117 deletions(-)
 create mode 100644 arch/arm/cpu/armv8/zynqmp/Kconfig
 create mode 100644 arch/arm/cpu/armv8/zynqmp/slcr.c
 create mode 100644 arch/arm/dts/zynq-zc770-xm011.dts
 delete mode 100644 board/xilinx/zynqmp/Kconfig
 rename configs/{xilinx_zynqmp_defconfig => xilinx_zynqmp_ep_defconfig}
(81%)
 create mode 100644 configs/zynq_zc770_xm011_defconfig
 create mode 100644 include/configs/xilinx_zynqmp_ep.h