[U-Boot] [PATCH v3 4/4] arm: ls102xa: Enable Driver Model SPI for ls1021atwr

[Bin Meng]

Hi Haikun,

On Mon, May 18, 2015 at 9:25 PM, Haikun Wang <haikun.wang at freescale.com> wrote:
> From: Haikun Wang <Haikun.Wang at freescale.com>
>
> Enable Driver Model SPI for ls1021atwr board.
> DSPI and QSPI only be enabled when boot from QSPI.
> DSPI and QSPI are compatible under Driver Model SPI.
>
> Signed-off-by: Haikun Wang <Haikun.Wang at freescale.com>
> Change-Id: I6342807da7725ae8b678952117c8758c75a61d3d
> Reviewed-on: http://git.am.freescale.net:8181/33447

Is this URL Freescale internal? I cannot access it.

> Tested-by: Review Code-CDREVIEW <CDREVIEW at freescale.com>
> Reviewed-by: Prabhakar Kushwaha <prabhakar at freescale.com>
> ---
> Changes in v3:
> - IS_ENABLED(CONFIG_XXX) is only work with configure option in Kconfig,
>   and DM core code use IS_ENABLED(), so configure option in head file
>   can't work, so remove CONFIG_OF_CONTROL CONFIG_OF_SEPARATE CONFIG_DM CONFIG_DM_SPI
>
> Changes in v2:
> - Move all changes inside of CONFIG_QSPI_BOOT
>
> Changes in v1: None
>  include/configs/ls1021atwr.h | 10 ++++++++--
>  1 file changed, 8 insertions(+), 2 deletions(-)
>
> diff --git a/include/configs/ls1021atwr.h b/include/configs/ls1021atwr.h
> index 729205f..13e3aa4 100644
> --- a/include/configs/ls1021atwr.h
> +++ b/include/configs/ls1021atwr.h
> @@ -229,16 +229,22 @@
>  #define CONFIG_CMD_FAT
>  #define CONFIG_DOS_PARTITION
>
> -/* QSPI */
> +/* SPI */
>  #ifdef CONFIG_QSPI_BOOT
> +/* QSPI */
>  #define CONFIG_FSL_QSPI
>  #define QSPI0_AMBA_BASE                        0x40000000
>  #define FSL_QSPI_FLASH_SIZE            (1 << 24)
>  #define FSL_QSPI_FLASH_NUM             2
>
> +#define CONFIG_SPI_FLASH_STMICRO
> +
> +/* DM SPI */
> +#if defined(CONFIG_FSL_DSPI) || defined(CONFIG_FSL_QSPI)
>  #define CONFIG_CMD_SF
> +#define CONFIG_DM_SPI_FLASH
>  #define CONFIG_SPI_FLASH
> -#define CONFIG_SPI_FLASH_STMICRO
> +#endif
>  #endif
>
>  /*
> --

Regards,
Bin