[U-Boot] [PATCH V2 1/2] usb: dwc2: fix aligned buffer usage

[Stephen Warren]

The original aligned_buffer usage:
a) Uselessly copied data into the aligned buffer even for IN
   transactions. Fix this my making the copy conditional.
b) Always programmed the HW to transfer to/from the start of the aligned
   buffer. This worked fine for OUT transactions since the memcpy copied
   the OUT data to this location too. However, for large IN transactions,
   since the copy from the aligned buffer to the "client" buffer was
   deferred until after all chunks were transferred. it resulted in each
   chunk's transfer over-writing the data for the first transfer. Fix
   this by copying IN data as soon as it's received.

Signed-off-by: Stephen Warren <swarren at wwwdotorg.org>
---
v2: Move all memcpy()s back into the per-chunk loop; we can't rely on
maxpacket being a multiple of 8-bytes, so we need to copy each chunk to
the aligned_buffer not aligned_buffer+done; the HW requires 8-byte
alignment for the DMA buffer.

 drivers/usb/host/dwc2.c | 14 ++++++++------
 1 file changed, 8 insertions(+), 6 deletions(-)

diff --git a/drivers/usb/host/dwc2.c b/drivers/usb/host/dwc2.c
index 5a1c44a8fb75..05d21b7948f5 100644
--- a/drivers/usb/host/dwc2.c
+++ b/drivers/usb/host/dwc2.c
@@ -795,7 +795,9 @@ int chunk_msg(struct usb_device *dev, unsigned long pipe, int *pid, int in,
 		       (*pid << DWC2_HCTSIZ_PID_OFFSET),
 		       &hc_regs->hctsiz);
 
-		memcpy(aligned_buffer, (char *)buffer + done, len - done);
+		if (!in)
+			memcpy(aligned_buffer, (char *)buffer + done, len);
+
 		writel((uint32_t)aligned_buffer, &hc_regs->hcdma);
 
 		/* Set host channel enable after all other setup is complete. */
@@ -810,16 +812,16 @@ int chunk_msg(struct usb_device *dev, unsigned long pipe, int *pid, int in,
 			break;
 		}
 
-		done += xfer_len;
 		if (in) {
-			done -= sub;
+			xfer_len -= sub;
+			memcpy(buffer + done, aligned_buffer, xfer_len);
 			if (sub)
 				stop_transfer = 1;
 		}
-	} while ((done < len) && !stop_transfer);
 
-	if (done && in)
-		memcpy(buffer, aligned_buffer, done);
+		done += xfer_len;
+
+	} while ((done < len) && !stop_transfer);
 
 	writel(0, &hc_regs->hcintmsk);
 	writel(0xFFFFFFFF, &hc_regs->hcint);
-- 
1.9.1